About this product
Description:
This is a general 1.5inch diagonal OLED display Module from Waveshare, 128×128 pixels monochrome dot matrix display module with 16 grayscales, and an embedded controller communicating via SPI or I2C interface. It is perfect when you need an ultra-small display.
Compared to LCD, OLED screens are way more competitive, which has a number of advantages such as high brightness, self-emission, high contrast ratio, slim outline, wide viewing angle, wide temperature range, and low power consumption. It is compatible with any 3.3V-5V microcontroller, such as Arduino. The characteristics of this display module are high brightness, self-emission, high contrast ratio, slim/thin outline, wide viewing angle, wide temperature range, and low power consumption.
Specification:
Operating voltage
3.3V / 5V
DISPLAY PANEL
OLED
Resolution
128 × 128 pixels
PIXEL SIZE
0.185 × 0.185mm
Communication Interface
4-wire SPI / I2C
Driver
SSD1327
Features:
128×128 high resolution.
16 grayscale, the better display effect.
Supports SPI or I2C interface, configured via an onboard resistor.
Comes with development resources and a manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32).
Pin Description:
VCC
Power (3.3V / 5V input)
GND
Ground
DIN
Data input
CLK
Clock input
CS
Chip selection, low active
DC
Data/Command selection (high for data, low for command)
RST
Reset, low active
Useful Link:
Waveshare 1.5" OLED Display Module Datahsheet
Package Included:
1 x Waveshare 1.5" OLED Display Module
1 x PH2.0 7Pin
128×128 high resolution.
16 grayscale, the better display effect.
Supports SPI or I2C interface, configured via an onboard resistor.
Comes with development resources and a manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32).