10 x 15 cm FR4 Copper Clad Plate Laminate Single Side PCB - RS2610
This Is A High Quality Single Sided Fr2 / Phenolic General Purpose PCB. It Is Used For Rapid Prototyping Design.
₹120.00 GST added at checkout
SKU KT966
Power Supply – 9v (from battery for whole project) The importance Pins look at table below. 1.) Pin 16 is positive power supply and pin 8 is a ground.
₹375.00
18% GST added at checkout
In stock
₹150 flat shipping, free over ₹3000
Buying for a school or in bulk? Ask us for institutional pricing. Get a quote
Power Supply – 9v (from battery for whole project)
Breadboard 840 points – 1
CD 4017 ic – 2
9v Battery -1
Battery snapper – 1
Single Stand Wire 2m -1
5 mm. Led - 8
HARDWARE REQUIRED
Breadboard 840 points – 1
CD 4017 ic – 2
9v Battery -1
Battery snapper – 1
Single Stand Wire 2m -1
5 mm. Led - 8
SOFTWARE REQUIRED
IC 4017
The importance Pins look at table below.
1.) Pin 16 is positive power supply and pin 8 is a ground. The power supply range of 3 volts to 16 volts and Maximum power supply voltage at pin 1 must not much than 18 volts.
2.) When “1” logic, the clock input is stop, and the counter does nothing even when clock pulse arrive.2.)Pin 13 is Clock enabled pins to controls the clock. When it is “0” logic, the clock is enabled and the counter advances one count for each clock pulse.
3.) Pin 14 is the clock triggers one count. The clock pulse must be “clean”. If they are “noisy” the counter may advance two or more times during each clock pulse.
4.) Pin 15 is the reset pin. Normally, it is “0”. When made “1”, the counter is reset to “0”.
5.) Pins 1-7 and 9-11 are the decoded output pins. The active count pin goes high and all others remain low.
6.) Pin 12 is Carry output, for the clock input of an additional counter or an external circuit that the count is complete.
LED
CIRCUIT DESCRIPTION
pin 16 to positive rail of breadboard
pin 15 of IC4017 to pin 5 of IC4017
pin 13 of IC4017 to pin 8 of IC4017 then it goes to negative rail
connect 5 led with their cathode to negative rail and anode to 1,2,3,4, & 7 pins of IC 4017
connect 6th led’s anode to pin 10 of IC4017 and cathode to negative rail
connect a wire to pin 14 of ic 4017 and leave it unplugged
now connect 9v battery to the breadboard to power up the connections.
WORKING Whenever you touch the wire which is showing unplugged Process of glowing change by led to led .
More in ICs & Prototyping
This Is A High Quality Single Sided Fr2 / Phenolic General Purpose PCB. It Is Used For Rapid Prototyping Design.
₹120.00 GST added at checkout
The universal PCB board is easy to weld diode, resistor, transistor, capacitor, etc. With referencing letters and numbers printed on the Single side for easy reference of
₹31.50 GST added at checkout
This is a 12" x 12" (30 cm x 30 cm) copper-clad PCB. This copper clad is perfect for hobbyists & electronics engineers who have tried successfully making their own single-sided
₹247.50 GST added at checkout
The 12x18cm Double Sided PCB Board Tinned Through Holes Universal Printed Circuit Proto Board. This means the PCB has copper traces (conductors) on both sides of the board.
₹171.00 GST added at checkout