About this product
KIT INCLUDES:
Breadboard 830 points – 1
9v Battery-1
Battery snapper – 1
Led(red,green,yellow) – 2 piece each
Resistor 330 ohm – 2
Transistor bc547 – 5
Single stand wire 2mt – 1
B-10 Buzzer -1
HARDWARE REQUIRED
Breadboard 830 points – 1
9v Battery-1
Battery snapper – 1
Led(red,green,yellow) – 2 piece each
Resistor 330 ohm – 2
Transistor bc547 – 5
Single stand wire 2mt – 1
B-10 Buzzer -1
SPECIFICATIONS
Power supply – 9V( from the 9v battery)
PIN DESCRIPTION
Led
BC547 TRANSISTOR
CIRCUIT DESCRIPTION
Connect the Components according to the given diagram above.
Connect the Components according to the given diagram above.
First TRANSISTOR BC547 collector connect with 330-ohm resistor to positive rail on the breadboard
Emitter connects to the positive terminal of led and negative terminal of led connects to the negative rail on breadboard
Base wire connects to the water tank
First, connect all the wire and components then connect the battery. Must use plastic glass for this project.
Second TRANSISTOR BC547 collector connect with 330-ohm resistor to positive rail on breadboard
Emitter connects to positive terminal of led and negative terminal of led connects to the negative rail on breadboard
Base wire connects to the water tank
Third TRANSISTOR BC547 collector connect with 330 ohm resistor to positive rail on breadboard
Emitter connects to positive terminal of led and negative terminal of led connects to the negative rail on breadboard
Base wire connects to the water tank
Positive wire from the positive rail on the breadboard connects with the water level.
Attach the buzzer on the breadboard.
Connect the positive terminal of the buzzer to the collector pin of the fourth transistor and the negative terminal of the buzzer to the GND rail of the breadboard.
Connect the emitter pin of forth Transistor to the positive rail on the breadboard.
Then connect the battery.
WORKING
When the water level reaches to point A circuit with green led & Transistor Q1 gets completed and green led glows.
Similarly when water level reaches to point B , Circuit with yellow led and transistor Q2 gets completed and yellow led glows.
Same goes with point C and finally when tank gets full at point D circuit with buzzer gets completed and buzzer starts beeping.