About this product
ENC28J60 SPI Ethernet Module with 12-Pin Header
Add wired Ethernet to a suitable microcontroller project with this ENC28J60-based module. The blue board shown has an RJ45 connector, a 25MHz crystal and a two-row, six-position connection header. The 12-pin description refers to that module header, not to the Ethernet controller IC's lead count.
Controller capabilities
Integrated Ethernet MAC and 10BASE-T PHY for 10Mbps Ethernet links.
SPI host interface with controller clock rates up to 20MHz.
8KB shared transmit/receive packet buffer.
Full- and half-duplex operation supported by the controller.
Hardware packet filtering, CRC handling and checksum assistance.
25MHz crystal oscillator on the pictured board, separate from the SPI interface clock.
Wiring and software
Use a regulated supply appropriate for the actual module revision. The ENC28J60 IC operates from a nominal 3.3V supply, but module power inputs and any onboard regulation must be verified before connection. Check every header label and the board pinout; do not substitute a diagram for a different 10-pin or 12-pin module. Verify logic levels for the whole connection, including signals returned to the host.
The module needs a compatible host controller, ENC28J60 driver and networking software. It is not a USB Ethernet adapter and does not provide Wi-Fi. The 20MHz SPI figure is an interface limit, not an Ethernet link rate or a guaranteed application throughput. Confirm that the connected network port supports a 10BASE-T link.
Project uses
Suitable for learning Ethernet interfacing, local-network sensor prototypes and embedded control experiments. Keep power stable, check wiring before applying power and use an appropriate enclosure for the finished project. Controller package suffix and board-level electrical protections are not claimed from the listing photographs.
Package contents
1 x ENC28J60 SPI Ethernet module with 12-pin header
Reference video