About this product
CH340G USB-to-TTL Serial Adapter
Connect a computer's USB port to a microcontroller's logic-level serial interface with this compact CH340G adapter. The board has a USB Type-A plug, a six-pin header and a yellow supply-selection jumper. It is useful for serial-console access, firmware-loading workflows that use a compatible UART bootloader, and testing embedded devices on the bench.
Board features
CH340G USB-to-UART bridge with onboard crystal.
USB Type-A plug for direct connection to a computer or suitable extension cable.
Header labels include 5V, VCC, 3V3, TXD, RXD and GND.
Supply-selection jumper and onboard indicator LEDs.
Compact board format for embedded-development toolkits.
Connect it correctly
Connect adapter TXD to the target's RX input, adapter RXD to target TX, and join the grounds. Check the actual signal voltage before connecting a voltage-sensitive target. A 3.3V power pin or jumper position does not by itself prove that every UART signal is safe for a 3.3V-only input. Use suitable level shifting when required.
This board provides logic-level UART connections. It is not a direct RS232, RS485 or RS422 adapter; those interfaces require the appropriate transceiver hardware. It is also not a universal microcontroller programmer. The target must support a compatible serial bootloader and any necessary reset or boot-mode wiring.
Software setup
Install the appropriate WCH USB-serial driver if your operating system does not already recognise the adapter. Select the assigned serial port and the target's baud rate in your terminal or programming software. Avoid powering a target from both this adapter and another supply unless the wiring is designed for it.
Package contents
1 x CH340G USB-to-TTL serial adapter board