0.96 OLED Display ESP32 ESP-32S WIFI BT Lora Module Board Antenna Transceiver for Arduino - RS1159
1 x 0.96 OLED Display ESP32 ESP-32S WIFI BT Lora Module Board Antenna Transceiver for Arduino
₹5698.50 GST added at checkout
SKU RS8432
Ra-01SC-P is a LoRa series module designed and developed by Shenzhen Ai-Thinker Technology Co., Ltd. This module is used for ultra-long distance spread spectrum communication.
₹600.00
18% GST added at checkout
In stock
₹150 flat shipping, free over ₹3000
Buying for a school or in bulk? Ask us for institutional pricing. Get a quote
Description:
Ra-01SC-P is a LoRa series module designed and developed by Shenzhen Ai-Thinker Technology Co., Ltd. This module is used for ultra-long distance spread spectrum communication. Its RF chip LLCC68+ mainly uses a LoRa™ long-range modem, which is used for ultra-long distance spread spectrum communication, has strong anti-interference ability, and can minimize current consumption. With the help of SEMTECH's LoRa™ patented modulation technology, the module has a built-in power amplifier (PA) and low-noise amplifier (LNA) on this technology, with high sensitivity exceeding -137dBm, +29dBm transmission power, long transmission distance, and high reliability.
At the same time, compared with traditional modulation technology, LoRa™ modulation technology also has obvious advantages in anti-blocking and selection, solving the problem that traditional design solutions cannot take into account distance, anti-interference, and power consumption at the same time.
Specifications:
Model: Ra-01SC-P
Antenna: Compatible with half-hole pad/through-hole pad/IPEX connector
Frequency: 410MHz~525MHz
Operating Temperature: -40℃~ 85℃
Storage Temperature: -40℃~ 125℃, < 90%RH
Power Supply: Supply voltage 3.0~3.6V, typical value 3.3V, current>1A
Interface: SPI
Programmable Bit Rate: Up to 300kbps
Features:
Supports FSK, GFSK, LoRa® modulation modes
Supports frequency band 410MHz~525MHz
Maximum transmit power +29dBm, operating current 700mA
High sensitivity: as low as -137dBm@SF10 125KHz
Extremely small size 17*16*3.2(±0.2)MM, double-row stamp hole patch package
Support spread factor SF5/SF6/SF7/SF8/SF9/SF10/SF11
Low power consumption in the receiving state, with a minimum receiving current of 11mA.
The module uses an SPI interface, half-duplex communication, with CRC, and a data packet engine of up to 256 bytes.
Supports multiple antenna installation methods, compatible with half-hole pads/through-hole pads/IPEX connector
Pin Description:
No. Name Function
1 ANT Connect antenna
2 GND Ground
3 3V3 Typical value 3.3V power supply
4 RESET Reset Pin
5 CPS FEM chip TX pass-through enable pin, in transmit mode, this pin is low level RFand is directly output without PA amplification and is internally pulled up by default
6 DIO1 Digital IO1 software configuration
7 DIO2 Digital IO2 software configuration
8 DIO3 Digital IO3 software configuration
9 GND Ground
10 BUSY Status indication pin
11 RF_EN FEM chip enable pin, high level is effective, the module is pulled up by default; High level is in a working state, low level is in sleep state
12 SCK SPI clock input
13 MISO SPI data output
14 MOSI SPI data input
15 NSS SPI chip select input
16 GND Ground
EPAD GND Ground, reliable grounding is required to facilitate heat dissipation
Useful Link:
Ai-Thinker LoRa Ra-01SC-P Module
Package Included:
1 x Ai-Thinker LoRa Ra-01SC-P Module
Supports FSK, GFSK, LoRa® modulation modes
Supports frequency band 410MHz~525MHz
Maximum transmit power +29dBm, operating current 700mA
High sensitivity: as low as -137dBm@SF10 125KHz
Extremely small size 17*16*3.2(±0.2)MM, double-row stamp hole patch package
Support spread factor SF5/SF6/SF7/SF8/SF9/SF10/SF11
Low power consumption in the receiving state, with a minimum receiving current of 11mA.
The module uses an SPI interface, half-duplex communication, with CRC, and a data packet engine of up to 256 bytes.
Supports multiple antenna installation methods, compatible with half-hole pads/through-hole pads/IPEX connector
| Model | Ra-01SC-P |
|---|---|
| Antenna | Compatible with half-hole pad/through-hole pad/IPEX connector |
| Frequency | 410MHz~525MHz |
| Operating Temperature | -40℃~ 85℃ |
| Storage Temperature | -40℃~ 125℃, < 90%RH |
| Power Supply | Supply voltage 3.0~3.6V, typical value 3.3V, current>1A |
| Interface | SPI |
| Programmable Bit Rate | Up to 300kbps |
More in LoRa Modules
1 x 0.96 OLED Display ESP32 ESP-32S WIFI BT Lora Module Board Antenna Transceiver for Arduino
₹5698.50 GST added at checkout
LoRa series module Ra-01Sc is designed and developed by Shenzhen Ai-Thinker This module is used for ultra-long distance spread spectrum Its RF chip LLCC68 mainly uses a LoRa™
₹433.50 GST added at checkout
This LoRa 433MHz module was designed by AI-THINKER, which is based on the chip SX1278. The SX1278 RF module is mainly used for long-range spread spectrum communication.
₹733.50 GST added at checkout