5V Single-Channel Relay Module with Optocoupler - RS5454

SKU RS5454

5V Single-Channel Relay Module with Optocoupler The RS5454 is a one-channel relay board for low-voltage control and switching experiments.

₹88.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

5V Single-Channel Relay Module with Optocoupler

The RS5454 is a one-channel relay board for low-voltage control and switching experiments. It combines a 5V relay, driver circuitry, status indicators, a three-pin control header and screw terminals for the relay contacts. It can be used in a controller-based project when the supply and input requirements are matched to the board.

Connections and operation

VCC: the board's 5V DC supply connection.

GND: supply/control reference. Check the printed labels before wiring.

IN: control input. Confirm the trigger polarity and input requirements with the actual board; do not assume every 5V relay module is active-high or works directly from 3.3V logic.

COM: common relay contact.

NO: normally open contact, connected to COM when the relay coil is energised.

NC: normally closed contact, connected to COM when the relay coil is not energised.

The relay contacts act as a switch; they do not supply power to the load. Confirm the contact terminal positions from the board's printed circuit symbol or a continuity test with all power disconnected. Use the contact arrangement that gives the required default state if control power is lost.

Before connecting a controller

Power the relay board from a suitable regulated 5V supply, not from a GPIO pin. Check the required supply current and the control-input current for the exact board. If a controller cannot meet the input requirements, use a suitable driver or interface. The optocoupler does not by itself establish complete galvanic isolation of the assembled board; shared grounds and PCB connections matter.

Load and electrical safety

Ratings printed on the relay case are component ratings under stated conditions, not a guarantee that the complete module, terminals, wiring or enclosure is suitable for every load at that value. Allow for load type, starting/inrush current, contact protection and installation conditions. Do not treat this bare board as a ready-to-use mains switch.

For learning and prototyping, start with an appropriately rated low-voltage load and disconnect all supplies before changing wires. Mains wiring requires suitable protection, enclosure, spacing and qualified installation. Keep hazardous voltages away from exposed controller connections.

Package includes

1 x 5V single-channel relay module with optocoupler. Controller, load, power supply and connecting wires are not included.

More in Relay Modules

You might also need