About this product
5V single-channel relay board with selectable trigger mode
RS5545 is a one-channel electromechanical relay module for switching a separate load from a controller signal. The photographed red PCB has a 5V relay, screw terminals and a jumper for high-level or low-level triggering. It is useful for low-voltage automation experiments, a lamp test or a controller-operated switch.
Connections and switching contacts
Module supply: 5V DC.
Control-side labels: DC+, DC- and IN.
Output contact labels: NO, COM and NC.
Trigger mode: selectable HIGH or LOW using the onboard jumper.
Package: one single-channel relay module.
With power disconnected, read the labels on the supplied PCB before wiring. DC+ and DC- are the module supply connections; IN is the control input. The screw-terminal positions are not interchangeable. Do not copy the terminal order from another relay board.
COM is the common switching contact. NO is normally open when the relay is not energised and closes to COM when it operates. NC is normally closed to COM and opens when it operates. These contacts do not provide a power supply for the load.
Controller setup
Select the trigger mode with power off. HIGH mode operates from a suitable high input; LOW mode operates when the input is pulled low. Verify the jumper labels and test switching before attaching the intended load. Check what the controller does during boot, reset and disconnection so an unexpected output does not start equipment.
A 5V module supply does not guarantee direct input compatibility with every ESP32, Raspberry Pi or other 3.3V-only GPIO. Verify the input voltage and current requirements or use a suitable interface. An optocoupler on a board does not by itself prove complete galvanic isolation of every connection.
Load and safety limits
The relay case carries contact ratings, but those markings are not a blanket continuous-current rating for the complete PCB, terminals or wiring. Check the load type, startup current, fusing and suppression requirements. Start with a safe low-voltage DC test. This exposed module is not a touch-safe mains assembly; mains installation requires a qualified person, a suitable enclosure and compliant wiring.
Controller, power supply, load, enclosure and connection leads are not included. SKU: RS5545.