About this product
5V 8-Channel Relay Module with Optocouplers
Control up to eight separate loads from a microcontroller project with this 5V relay board. Each channel has a mechanical relay, an indicator LED and screw terminals for normally open, normally closed and common connections. The board suits low-voltage automation experiments, test fixtures and Arduino-based switching projects.
Features
Eight independently controlled relay channels on one board.
5V DC relay-coil supply.
Optocouplers on the input circuits and transistor relay drivers.
IN1 to IN8 control connections with channel-status indicators.
COM, NO and NC screw terminals for each output.
VCC/JD-VCC jumper arrangement for the control and relay supply connections.
Specifications
Parameter
Details
Channels
8
Relay supply
5V DC
Relay contact arrangement
SPDT: common, normally open and normally closed
Control inputs
IN1 to IN8; low-level trigger on this module type
Connections
Control pin header and load screw terminals
SKU
RC024
Wiring and power notes
Use a regulated 5V supply with enough current for the number of relays energised together. Do not power relay coils from a microcontroller GPIO pin. Check the board's printed pin labels before connecting VCC, GND and IN1 to IN8. Verify trigger behaviour with a safe, low-voltage test load before connecting the final circuit.
The VCC/JD-VCC jumper commonly links the input and relay supplies. Having optocouplers on the board does not guarantee complete galvanic isolation in every wiring arrangement. Check the actual circuit and ground connections before choosing a separate-supply configuration. Direct 3.3V-controller compatibility is not guaranteed; use a suitable interface if needed.
COM is the common terminal. With a relay de-energised, COM connects to NC; when energised, COM connects to NO. The rating printed on an individual relay is not a blanket safe-load rating for the complete board. Load type, inrush current, PCB spacing, terminal wiring and enclosure all matter.
Safety
This is an exposed electronics module, not an enclosed or certified mains-control appliance. Start with low-voltage loads. Mains wiring requires a qualified person, suitable protection and an insulated enclosure. Never touch or rewire an energised circuit.
Package contents
1 x 5V 8-channel relay module with optocouplers. Controller, power supply, wiring and demonstration loads are not included.
Eight independently controlled relay channels on one board.
5V DC relay-coil supply.
Optocouplers on the input circuits and transistor relay drivers.
IN1 to IN8 control connections with channel-status indicators.
COM, NO and NC screw terminals for each output.
VCC/JD-VCC jumper arrangement for the control and relay supply connections.