About this product
Description
The device consists of a precise, low-offset, linear Hall circuit with a copper conduction path located near the surface of the die. Applied current flowing through this copper conduction path generates a magnetic field which the Hall IC converts into a proportional voltage.
Specifications:
Chip: ACS712ELC-20A
The low-noise analog signal path
Device bandwidth is set via the new FILTER pin
5 µs output rise time in response to step input current
Small footprint, low-profile SOIC8 package
2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
Supply Voltage: 4.5V~5.5V DC
Measure Current Range: 20A
Sensitivity: 100mV/A
Features:
Brand new 20A Range ACS712 Current Sensor Module for Arduino
Current sensor chip: ACS712ELC-20A
Pin 5V power supply, onboard power indicator
The module can measure the positive and negative 20A, corresponding to the analog output 100mV/A
There is no detection current through, the output voltage is VCC/2
Great for the DIY project.
Note:
ACS712 Hall detection principle, when you use to avoid magnetic field impact this.
Package Included:
1 x 20A range ACS712 current sensor module
Brand new 20A Range ACS712 Current Sensor Module for Arduino
Current sensor chip: ACS712ELC-20A
Pin 5V power supply, onboard power indicator
The module can measure the positive and negative 20A, corresponding to the analog output 100mV/A
There is no detection current through, the output voltage is VCC/2
Great for the DIY project.