About this product
12V 1-Channel Relay Module without Optocoupler
Add a single switched output to an electronics project with this compact 12V relay module. It combines a mechanical relay, driver components, status LEDs and screw terminals on one board. Use the common, normally open and normally closed contacts to choose whether a low-voltage load is on or off when the relay is at rest.
Features
One relay channel with a 12V DC coil supply.
Simple non-optoisolated driver-board design.
VCC, GND and IN connections on the control header.
COM, NO and NC load connections on screw terminals.
Onboard power and relay-status indicators.
Useful for low-voltage switching prototypes, test fixtures and automation experiments.
Specifications
Parameter
Details
Channels
1
Relay supply
12V DC
Contact type
SPDT: COM, normally open and normally closed
Optocoupler
Not fitted
Control connections
VCC, GND and IN; follow the board markings
SKU
NA187
Connection notes
Power the board from a suitable regulated 12V DC supply. Do not connect 12V to an Arduino or Raspberry Pi GPIO pin, and do not try to power the relay coil from a GPIO output. This board does not have an optocoupler, so its control input is not optically isolated.
Verify the input trigger voltage and polarity for the supplied board before connecting a controller. Direct 3.3V or 5V GPIO compatibility is not guaranteed for this module. Use a suitable driver or level interface where required and test with a safe low-voltage load first.
With the relay de-energised, COM connects to NC. When energised, COM connects to NO. Identify the terminals from the printed markings rather than assuming their left-to-right order. Choose a load within the actual relay, PCB and terminal limits, allowing for motor or lamp inrush current.
Safety
This exposed module is not an enclosed or certified mains-control appliance. Relay contact markings alone do not establish a safe rating for a complete installation. Mains wiring requires a qualified person, suitable protection and an insulated enclosure. Disconnect power before wiring or handling the board.
Package contents
1 x 12V 1-channel relay module without optocoupler. Controller, power supply, wires and demonstration loads are not included.
One relay channel with a 12V DC coil supply.
Simple non-optoisolated driver-board design.
VCC, GND and IN connections on the control header.
COM, NO and NC load connections on screw terminals.
Onboard power and relay-status indicators.
Useful for low-voltage switching prototypes, test fixtures and automation experiments.