About this product
Power supply: 5V
Logic level: 5V/3.3V (3.3V by default)
Overall current (idle mode): ~18mA
Single module current (VBAT=3.3V):
Idle mode: 5.6mA
Sleep mode: 0.4mA
PSM mode: 5uA
eDRX mode: 70uA (eDRX=655.36s)
Dimension: 30.5mm x 65.0mm
Description :
This is an NB-IoT (NarrowBand-Internet of Things) HAT for Raspberry Pi, controlled via serial AT commands, supports communication protocols like LWM2M/COAP/MQTT, etc. Due to the advantages of low delay, low power, low cost, and wide coverage, it is the ideal choice for IoT applications such as intelligent instruments, asset tracking, remote monitoring, and so on.
Features
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
Supports communication protocols such as LWM2M/COAP/MQTT/TCP/UDP/HTTP/HTTPS, etc.
Onboard USB interface, for power supply OR debugging
Breakout UART control pins, to connect with host boards like Arduino/STM32
Onboard voltage translator, 3.3V by default, allows to be switched to 5V via onboard jumper
SIM card slot, supports NB-IoT specific card
2x LED indicators, easy to monitor the working status
Baudrate: 300bps~921600bps (115200bps by default)
Control via AT commands (V.25TER, 3GPP TS 27.007, and SIMCOM AT Commands)
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32/Python)
Communications Specifications
Band : FDD-LTE B1/B3/B5/B8/B20/B28
Data rate
Uplink≤62.5Kbps
Downlink≤26.15Kbps
SMS :Text mode and PDU mode (depends on the NB card)
General Specifications
Power supply: 5V
Logic level: 5V/3.3V (3.3V by default)
Overall current (idle mode): ~18mA
Single module current (VBAT=3.3V):
Idle mode: 5.6mA
Sleep mode: 0.4mA
PSM mode: 5uA
eDRX mode: 70uA (eDRX=655.36s)
Dimension: 30.5mm x 65.0mm
Development Resources
Wiki :www.waveshare.com/wiki/SIM7020E_NB-IoT_HAT
Recommendation
CP2102 USB UART Board(micro) is recommended for easy testing.
Package Included :
SIM7020E NB-IoT HAT x1
Antenna x1
USB type A plug to micro plug cable x1
RPi screws pack (2pcs) x1
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
Supports communication protocols such as LWM2M/COAP/MQTT/TCP/UDP/HTTP/HTTPS, etc.
Onboard USB interface, for power supply OR debugging
Breakout UART control pins, to connect with host boards like Arduino/STM32
Onboard voltage translator, 3.3V by default, allows to be switched to 5V via onboard jumper
SIM card slot, supports NB-IoT specific card
2x LED indicators, easy to monitor the working status
Baudrate: 300bps~921600bps (115200bps by default)
Control via AT commands (V.25TER, 3GPP TS 27.007, and SIMCOM AT Commands)
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32/Python)