About this product
Description:
The 2-CH UART TO ETH provides an easy way to communicate between UART TTL and RJ45 Ethernet, allowing bi-directional transparent data transmission. It is easy to use, along with features like fast data rate, low power consumption, high stability, suits applications such as safety & security, IoT, and so on.
Specifications:
Operating voltage
3.3V/5V
Operating current
140mA
Operating mode
TCP/UDP
UART baudrate
300bps ~ 921.6Kbps
UART TTL level
3.3V / 5V compatible
Storage temperature
-55℃ ~ 125℃
Operating temperature
-40℃ ~ 85℃
Features:
Embedded Ethernet MAC and PHY layers.
Bi-direction transparent data transmission between UART and Ethernet.
10/100M, full-duplex/half-duplex auto-negotiation Ethernet interface, 802.3-compliant.
Auto-MDI/MDIX, detect and switch cable type automatically.
Supports DHCP auto-obtained IP and DNS domain access.
Network parameter configuration like chip operating mode, port, IP, via host computer software or UART command.
Four operating modes: TCP CLIENT, TCP SERVER, UDP CLIENT, UDP SERVER.
2-CH UART concurrent operation, standalone transparent transmission for each channel.
Full-duplex or half-duplex UART communication supports RS485 RX/TX auto switch.
Supports virtual serial port software (provided).
KEEPALIVE mechanism support.
What's On Board:
UART 1 connection status indicator
UART 2 connection status indicator
Power indicator
CH9121 control pins
CH9121 driver
AMS1117-3.3V power supply IC
RT9193-18GB power supply IC
Ethernet port
Pin Description:
5V/3V3
power positive, use any pin of 5V/3.3V pins for power supply
GND
ground
RST1
external reset input, low active
RESET
restore to factory setting, detected when chip power on, low active
TXD1
asynchronous UART 1 data output (enabled by default)
TXD2
asynchronous UART 2 data output (disabled by default)
RXD1
asynchronous UART 1 data input (enabled by default)
RXD2
asynchronous UART 2 data input (disabled by default)
CFG0
UART config mode, low level to enter configuration, high level to exit configuration
RUN
Operating status indicating pin
DIR1
UART 1 RS485 RX/TX switch (connects to external RS485 controller)
DIR2
UART 2 RS485 RX/TX switch (connects to external RS485 controller)
Useful Link:
2-CH UART TO ETH
Package Included:
1 x 2-CH UART TO ETH Converter
Embedded Ethernet MAC and PHY layers.
Bi-direction transparent data transmission between UART and Ethernet.
10/100M, full-duplex/half-duplex auto-negotiation Ethernet interface, 802.3-compliant.
Auto-MDI/MDIX, detect and switch cable type automatically.
Supports DHCP auto-obtained IP and DNS domain access.
Network parameter configuration like chip operating mode, port, IP, via host computer software or UART command.
Four operating modes: TCP CLIENT, TCP SERVER, UDP CLIENT, UDP SERVER.
2-CH UART concurrent operation, standalone transparent transmission for each channel.
Full-duplex or half-duplex UART communication supports RS485 RX/TX auto switch.
Supports virtual serial port software (provided).
KEEPALIVE mechanism support.