About this product
Volcano-Style Brass Nozzle, 1.75mm Filament and 0.4mm Orifice
The RS3168 is a long-thread brass nozzle for a compatible Volcano-style heater block. It is listed for 1.75mm filament with a 0.40mm outlet. The long threaded body distinguishes this nozzle format from a standard short V6 nozzle. Check the full mechanical fit before ordering a replacement.
This is a generic compatible component, not a claim of genuine E3D manufacture. A printer model name alone does not establish fit because printers may have different hotends or upgrades. It is not a drop-in replacement for every V6, MK8, MK10, Prusa or LulzBot hotend.
Specifications
Nozzle format: long-thread Volcano style.
Material: brass alloy.
Filament input: 1.75mm nominal.
Nozzle outlet: 0.40mm nominal.
Package quantity: one nozzle. Multi-nozzle photos illustrate different views and are not a pack-quantity promise.
Check compatibility
Compare the thread diameter and pitch, threaded length, overall length, sealing face and tip position with your existing nozzle and the heater-block drawing. A nozzle must seal correctly against the heatbreak or intended internal sealing surface. Matching threads alone do not prove a safe fit, and the hex shoulder should not be used as the only fit check.
Use a heater block designed for the long nozzle format. Standard short V6 and Volcano-style nozzles are different formats. Confirm tool access and clearance from the fan duct, probe and print surface after installation.
Material and printing notes
Brass is suited to ordinary non-abrasive filament use. Abrasive carbon-fibre, glass-filled, glow and similar filaments can wear a brass outlet; choose a suitable wear-resistant nozzle when needed. This listing does not establish an exact alloy, coating, maximum temperature or tested volumetric-flow rate for the supplied nozzle.
The long melt-zone format does not guarantee faster or stronger prints by itself. Heater power, sensor, hotend construction, filament, extrusion force and slicer settings all affect results. Set the slicer to the correct 0.4mm nozzle and tune flow, retraction and speed for your setup.
Installation checks
Follow the hotend maker's nozzle-change and hot-tightening instructions for the actual assembly, including its temperature and torque limits. Do not apply a generic temperature or torque copied from a different hotend. Hot metal can cause burns, and unsupported tightening can damage the nozzle, heater block, heatbreak or wiring. Recheck nozzle height/Z offset and inspect for leaks before printing.
Package includes
1 x Volcano-style brass nozzle for 1.75mm filament with 0.40mm outlet. Heater block, heatbreak and tools are not included.