About this product
V6-Style Bowden Hotend Kit - 1.75mm Filament, 0.4mm Nozzle
The RS2699 is a V6-style hotend kit for compatible Bowden-fed 3D printers and RepRap projects. It is listed for 1.75mm filament with a 0.4mm nozzle. The heatsink, heatbreak, heater block and nozzle form the filament path, while the fan and duct cool the heatsink.
This is a hotend assembly, not a complete filament-feeding extruder. Check the mounting arrangement, Bowden tube fit, nozzle position and wiring against your printer before ordering. V6-style appearance alone does not confirm compatibility with every V6 accessory or printer.
Fit and setup checks
Filament size: 1.75mm.
Listed nozzle opening: 0.4mm.
Feed arrangement: Bowden / compatible RepRap-style setup.
Listed cable length: approximately 30cm; check usable reach and provide strain relief.
Confirm the heater and fan voltage, heater power and temperature-sensor type before connecting to the printer controller.
Temperature and electrical safety
Do not assume this generic kit has the temperature rating, sensor calibration or internal construction of a genuine E3D hotend. A safe operating temperature depends on the actual heatbreak, PTFE arrangement, sensor, heater and other fitted parts. No maximum temperature is specified here. PTFE-lined parts must stay within their verified temperature limits.
Disconnect power before wiring or mechanical work. Match all component ratings to the power supply and controller, secure the heater and sensor correctly, and keep cables away from the heater block. Configure the correct temperature sensor and thermal protection in the printer firmware. Verify temperature readings and heatsink cooling before printing. Hot parts can cause burns; do not leave initial heating tests unattended.
What the parts do
The heatsink and fan keep the incoming filament path cool. The heatbreak separates this region from the hot heater block and nozzle. The temperature sensor provides feedback to the controller; it is not a heater supply connection. Follow assembly and tightening instructions suitable for the exact parts fitted rather than applying a generic temperature or torque setting.
Package
1 x V6-style hotend kit with the components shown in the product photos. Printer, controller, power supply, extruder drive and filament are not included. Check heater-cartridge inclusion and individual component ratings before assembly.