Turn off and on the fan by touching the switch - KT964

SKU KT964

The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open).

₹345.00

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

KIT INCLUDED:

Breadboard 400 points – 1

Fan or rotor – 1

9V Battery - 1

Snapper – 1

Single stand wire 2m - 1

555 timer ic – 1

Non-Geared Dc motor – 1

HARDWARE REQUIRED

Breadboard 400 points – 1

Fan or rotor – 1

9V Battery - 1

Snapper – 1

Single stand wire 2m - 1

555 timer ic – 1

Non-Geared Dc motor – 1

PIN DESCRIPTION 555 TIMER IC

Pin

Name

Purpose

1

GND

Ground reference voltage, low level (0 V)

2

TRIG

The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. Output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin.

3

OUT

This output is driven to approximately 1.7 V below +Vcc, or to GND.

4

RESET

A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold.

5

CTRL

Provides “control” access to the internal voltage divider (by default, 2/3 Vcc).

6

THR

The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open).

7

DIS

Open collector output which may discharge a capacitor between intervals. In phase with output.

8

Vcc

Positive supply voltage, which is usually between 3 and 15 V depending on the variation.

CIRCUIT DESCRIPTION

Pin 1 of 555 TIMER IC to negative rail of BREADBAORD

pin 8 of of 555 TIMER IC positive rail of BREADBOARD

connect pin 4 of 555 TIMER IC to pin 8 of 555 TIMER IC

connect two steel metal pin plate at pin 1 and 2 of 555 TIMER IC

connect two steel metal pin plate at pin 6 and 8 of 555 TIMER IC

connect dc motor one point at pin 1 of 555 TIMER IC and another point at pin 3 of 555 TIMER IC

WORKING

When we touch the lower steel pins, motor will turn on and started rotating.

When we touch the upper steel pins, motor will turn off.

More in Switches & Buttons

You might also need

12MM SFE Push Button Switch - RC110

12MM SFE Push Button Switch - RC110

The SFE 12mm Push Button Switch is a standard 12mm square momentary button. It features the large button head and good tactile feel.

₹7.50 GST added at checkout