About this product
TTP229 16-Key Capacitive Touch Keypad
Add a flat touch interface to an Arduino or other microcontroller project with this TTP229 keypad module. Its 4 x 4 layout has 16 numbered touch pads for menus, control panels, access-code experiments and interactive electronics. There are no moving button contacts.
Features
16 capacitive touch pads in a 4 x 4 layout.
TTP229 controller with configurable 8-key and 16-key operation.
SCL clock and SDO data connections for the module's two-wire serial interface.
OUT1 to OUT8 connections for individual key outputs in the appropriate 8-key mode.
Suitable for Arduino projects and other controllers with compatible supply and logic levels.
Specifications
Parameter
Details
Controller
TTP229 capacitive touch controller
Touch-pad layout
4 x 4, 16 numbered pads
Supply voltage
2.4V to 5.5V with the controller's internal regulator enabled
Serial connections
SCL clock input and SDO data output
Individual outputs
OUT1 to OUT8 in 8-key mode
SKU
NA064
Connection and setup notes
Connect VCC and GND to a suitable supply and share ground with the controller. For serial reading, connect SCL and SDO to suitable controller pins and use code written for the TTP229 two-wire protocol. The two-wire interface on this common module should not be assumed to be a standard I2C connection merely because it has a clock pin.
Common TTP229 keypad boards start in 8-key mode. Reading all 16 keys may require enabling the 16-key option at the TP2/KYSEL configuration pads. Check the markings and layout on the supplied board before changing any link, then power-cycle after configuration. Individual OUT1 to OUT8 pins are not 16 separate key outputs.
Keep fingers away from the touch pads for approximately 0.5 seconds after power-up while the controller calibrates. Use logic levels that are safe for both the keypad and controller. Wiring, configuration and suitable code are required; this is not a USB keyboard.
Package contents
1 x TTP229 16-key capacitive touch keypad module. Microcontroller, jumper wires and demonstration accessories are not included.
16 capacitive touch pads in a 4 x 4 layout.
TTP229 controller with configurable 8-key and 16-key operation.
SCL clock and SDO data connections for the module's two-wire serial interface.
OUT1 to OUT8 connections for individual key outputs in the appropriate 8-key mode.
Suitable for Arduino projects and other controllers with compatible supply and logic levels.