About this product
KIT INCLUDES
Arduino Uno with USB Cable - 1
Servo motor (FutabaS3003) - 1
Jumper wires (Male to Male) – 40 pcs
9v Battery
DC jack - 1
HARDWARE REQUIRED
Arduino Uno with USB Cable - 1
Servo motor (FutabaS3003) - 1
Jumper wires (Male to Male) – 40 pcs
9v Battery
DC jack - 1
SOFTWARE REQUIRED
Arduino IDE 1.8.5 (programmable platform for Arduino)
Click To Download :https://www.arduino.cc/en/Main/Software
PIN DESCRIPTION
Futaba S3033 Servo Motor
Operating Voltage: 4.8-6.0 Volts
Operational current: 100mA
Operating Speed (4.8V): 0.23sec/60 degrees at no load
Operating Speed (6.0V): 0.19sec/60 degrees at no load
Stall Torque (4.8V): 44 Oz/in. (3.2kg.cm)
Stall Torque (6.0V): 56.8 Oz/in. (4.1kg.cm)
Motor Type: 3 Pole Ferrite
Operating Angle: 45 Deg. one side pulse traveling 400µsec
CIRCUIT CONNECTION
Servo positive point to arduino 5v
servo negative to arduino ground
servo signal (white) to arduino D9
Other testing processes:
1.Open the servo motor from the bottom ,you see the two points of motor, put the 9v battery positive and negative point if the motor is in running position it will rotate otherwise there is some fault.
2. The second method is apply the positive and negative points of 9v battery to the servo positive and negative if it rotates it’s in good condition otherwise it have some fault.
CODE
Click to see the code
https://docs.google.com/document/d/e/2PACX-1vQ-bfq8_rBpRPsPCPXFcHexXbScxw2Gj2IODMGK-VgJ5nNiO2WOHSsfeePNKGNyG9vvtrVOMcoikeNe/pub
WORKING
After Uploading the code you can check the servo whether it is working or not.