Test a dust and Smoke detector and display the measured data on serial monitor interfacing with arduino leonardo - KT807

SKU KT807

Able to upload sketches via the Arduino IDE to your Arduino Hook up the sensor using the 6 pins in the following way (see Figure below) 3.3V Pin (150 Ohm in between and 220uf

₹1425.00

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

KIT INCLUDES:

Arduino Leonardo with USB cable-1

DSM 501A DUST SMOKE PARTICLE SENSOR - 1

220 uF Capacitor - 2

150 Ω Resistor - 2

Breadboard 400 points - 1

Male to male jumper wires- 1

Single stand wire 2mt- 1

HARDWARE REQUIRED

Arduino Leonardo with USB cable-1

DSM 501A DUST SMOKE PARTICLE SENSOR - 1

220 uF Capacitor - 2

150 Ω Resistor - 2

Breadboard 400 points - 1

Male to male jumper wires- 1

Single stand wire 2mt- 1

SPECIFICATION

DSM 501A dust sensor

Rated Power: 0.5W

Operating Voltage: 5V

Operating Current: 100mA

Operating Temperature: -20+or-85 degree

Light Intensity: 1000W/M2, 25 degree,AM1.5

CIRCUIT CONNECTION

Able to upload sketches via the Arduino IDE to your Arduino

Hook up the sensor using the 6 pins in the following way (see Figure below)

You may use the following schema from Sharp and our own drawing to help you in the task:

Sharp Dust Sensor

Attached To

1 (V-LED)

3.3V Pin (150 Ohm in between and 220uf capacitor)

2 (LED-GND)

GND Pin

3 (LED)

Digital Pin 12

4 (S-GND)

GND Pin

5 (Vo)

Analog Pin A5

6 (Vcc)

3.3V Pin (Direct)

According to the datasheet, we need to switch on the internal LED and wait for 280 µs (microsecond) before measuring the output signal and the duration of the whole excitation pulse should be 320 µs.

We, therefore, pause for another 40 µs before switching off the LED again.

CODE https://docs.google.com/document/d/e/2PACX1vQgJLF0BebJMEpubLBDBHLvDdZkQC4UcuonxG3q-yMp7t0rP_0quL8wIWytzidYcjQMEkAe2l-bXRgd/pub

WORKING

More in Arduino Boards

You might also need