About this product
KIT INCLUDES:
16*2 i2c DISPLAY - 1
Arduino uno with USB cable - 1
Jumper wire(male to female) – 40 pieces
9v battery-1
DC jack – 1
In this project you will see how to connect i2c LCD display to arduino and how to print on LCD display.
Each I2C bus consists of two signals: SCL and SDA. SCL is the clock signal, and SDA is the data signal. The clock signal is always generated by the current bus master; some slave devices may force the clock low at times to delay the master sending more data (or to require more time to prepare data before the master attempts to clock it out). This is called “clock stretching”
HARDWARE REQUIRED
16*2 i2c DISPLAY - 1
Arduino uno with USB cable - 1
Jumper wire(male to female) – 40 pieces
9v battery-1
DC jack – 1
SOFTWARE REQUIRED
Arduino IDE 1.8.5 (programmable platform for Arduino)
Click To Download :https://www.arduino.cc/en/Main/Software
SPECIFICATIONS
I2C LCD Serial Module
IC/I2C Interface Adapter Module is used for 16×2 LCD Display. It uses the PCF8574T IC chip which converts I2C serial data to parallel data for the LCD display. Also this interface module simplifies connecting an Arduino to a 16×2 Liquid Crystal display using only 4 wires.
Supply Voltage: 5V
Interface: I2C
Compatible for 16×2 LCD
Brightness and Contrast can be adjusted by the Potentiometer
16*2 LCD
LCD Display Mode: STN, Positive, Transflective
Display Color: Deep Blue/ Yellow Green
Viewing Angle: 6H
Driving Method : 1/16 duty, 1/5 bias
Back Light : Yellow-Green LED backlight
Outline Dimension: 803615.8 MAX
PIN DESCRIPTION
I2C LCD Serial Monitor
16*2 LCD
Symbol
External Connection
Function
VSS
Power Supply
Signal GROUND for lcm
VDD
POWER SUPPLY for logic lcm
V0
Contrast Adjust
RS
MPU
Register Select Signal
RW
MPU
Read/Write Select Signal
E
MPU
Operation Enable Signal
DB0~DB3
MPU
Four Low order bidirectional three state bus lines. Used for data transfer between the MPU and LCM. These four are not used between 4 Bit operations.
DB4~DB7
MPU
Four high order bidirectional Three state bus lines used for data transfer between the MPU
A
LED BKL power Supply
Power Supply for BKL
K
CIRCUIT CONNECTION
Attach the LCD display with I@C as given in diagram below:
I2C SHIELD
Arduino uno
Gnd
Gnd
Vcc
5v
SDA
A4
SCL
A5
CODE
Click to see the code or copy the link:
https://docs.google.com/document/d/e/2PACX-1vQy2uxOkll2BakGIkd1q8KoxZ9ikmYRmuTMAK4c_5qAe2_9mLWIHsMkybG7OMVi-mJ6mrmxSRZ-V3mr/pub
WORKING
Upload the code and must check your connection before uploading the code