Tap and Knock Sensor Module for Digital Input Projects - RS973

SKU RS973

Spring-contact knock sensor for tap-detection projects RS973 is a three-pin tap and knock sensor module for learning how to detect brief mechanical events with a microcontroller.

₹58.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

Spring-contact knock sensor for tap-detection projects RS973 is a three-pin tap and knock sensor module for learning how to detect brief mechanical events with a microcontroller. The photographed board carries an enclosed spring-contact sensor, a resistor and a three-pin header. A tap or vibration can momentarily close the internal contact, so the module behaves like a switch rather than measuring impact force. What it detects

Brief taps, knocks and mechanical vibration reaching the sensor.

Switch-like events for a controller's digital input circuit.

A short state change rather than a sustained button press.

Existing listing supply specification: 3 to 5V DC, with the input circuit and logic voltage checked first.

Use it for a classroom LED demonstration, tap-event counter or experimental notification project. It is not an analogue piezo sensor, sound microphone, accelerometer or calibrated force meter. Detection depends on how the module is mounted and the direction and strength of the vibration; no fixed sensitivity or detection-distance claim is made. Check the supplied circuit before connecting Similar spring-knock boards exist with different resistor connections. With power disconnected, inspect the supplied board and use a multimeter to identify the switch and resistor paths. Match the pull-up or pull-down circuit to that verified layout. Do not assume a generic S, middle and minus pin diagram applies to every version. Keep the sense voltage within the controller's input limits. A 3.3V-only GPIO must not be pulled up to 5V. Confirm a common ground where the chosen circuit requires one, and do not swap connections with power applied. Read events, not force Test the idle and tapped states before writing the final program. The active reading may be HIGH or LOW depending on the circuit. Mechanical contact bounce can create several transitions from one tap, so add suitable debounce and check for missed short pulses. If an LED must remain lit, hold that indication with software timing rather than expecting a long sensor pulse. Mounting and package Mount the board securely on the test surface, keep it dry and check for unwanted triggers from nearby vibration. Includes 1 x tap/knock sensor module. Controller, jumper wires, indicator and power supply are not included. SKU: RS973.

More in Sensor Modules

You might also need