About this product
SUNLU Silk PLA+ 3D Printer Filament - Blue Purple Orange Yellow, 1.75mm, 1kg
SUNLU Silk PLA+ Four Color weaves four glossy shades (blue purple orange yellow) into a single 1.75mm filament, producing a vivid multi-colour finish that shifts as you move around the printed part. It is the easiest way to get eye-catching multi-colour prints from a single-spool, single-nozzle printer - no AMS, no painting.
Every spool is produced with laser-monitored diameter control and held to a tight 1.75 ± 0.02 mm tolerance, keeping extrusion smooth and consistent through long prints. SUNLU's fully automated winding lays the filament 100% neatly on the spool - no knots, no tangles, no mid-print failures. It is clog, bubble, tangle and warping resistant, and runs on virtually any 1.75mm FDM printer - Bambu Lab, Creality, Anycubic, Prusa, Elegoo and more - with no special tuning.
Key Features
Silky glossy finish: smooth, shiny surface straight off the bed - no polishing or painting needed.
100% neatly wound: SUNLU's automated spooling prevents knots and tangles that ruin prints.
Precise 1.75 ± 0.02 mm diameter: laser-monitored consistency for even extrusion and clean layers.
Easy to print: prints like regular PLA - low warping, great layer adhesion, no enclosure needed.
Reusable 3rd-generation spool: multi-hole design dries thoroughly and works with spool refills.
Wide compatibility: works with 99% of 1.75mm FDM 3D printers, including AMS and AMS Lite systems.
Technical Specifications
Material
Silk PLA+ (glossy silk-effect PLA)
Colour
Blue Purple Orange Yellow (Four Color)
Diameter
1.75mm (± 0.02mm tolerance)
Net weight
1kg spool
Nozzle temperature
205-215°C (50-100mm/s), 215-235°C (100-200mm/s)
Bed temperature
50-60°C
Print speed
50-100mm/s standard, up to 200mm/s with higher temperature
Spool dimensions
8.00" diameter, 2.50" width, 2.20" hub hole
What is it good for?
Show-piece vases, character models, festive decor, gifts and market-stall prints. The blue purple orange yellow blend gives a rich multicolour shimmer that reads differently from every angle.
In the box
1 x SUNLU Silk PLA+ filament spool, Blue Purple Orange Yellow, 1.75mm, 1kg net weight
Good to know
The colour you see at any point depends on the spool position and part geometry - expect a lively mix rather than sharp colour bands.
Silk PLA+ absorbs moisture over time. If you hear popping or see stringing, dry the spool at 50-55°C for 4-6 hours.
Store sealed with desiccant when not in use.
Silky glossy finish: smooth, shiny surface straight off the bed - no polishing or painting needed.
100% neatly wound: SUNLU's automated spooling prevents knots and tangles that ruin prints.
Precise 1.75 ± 0.02 mm diameter: laser-monitored consistency for even extrusion and clean layers.
Easy to print: prints like regular PLA - low warping, great layer adhesion, no enclosure needed.
Reusable 3rd-generation spool: multi-hole design dries thoroughly and works with spool refills.
Wide compatibility: works with 99% of 1.75mm FDM 3D printers, including AMS and AMS Lite systems.