SimonK

SimonK 30A Brushless ESC for 2S-3S LiPo, Without Connectors - RS7311

SKU RS7311

SimonK 30A Brushless ESC Without Power or Motor Connectors The RS7311 is a sensorless brushless-motor electronic speed controller for RC aircraft and multirotor projects.

₹403.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

SimonK 30A Brushless ESC Without Power or Motor Connectors

The RS7311 is a sensorless brushless-motor electronic speed controller for RC aircraft and multirotor projects. Its photos show a red-wrapped controller with two battery leads, three motor-phase leads and a three-wire receiver/control lead. The battery and motor leads are supplied without fitted connectors, so suitable connectors or soldered joints must be prepared and insulated before use.

Listed specifications

Controller type: SimonK 30A-class brushless ESC.

Listed continuous-current rating: 30A. Actual safe loading depends on cooling, wiring and the motor/propeller combination.

Listed battery compatibility: 2S-3S LiPo. Do not assume 4S compatibility.

Listed BEC output: 5V, 2A. Check the supplied unit's output and the complete receiver/servo load before use.

Control: conventional RC throttle/PWM signal from a compatible receiver, flight controller or suitable controller interface.

The firmware build, programming options and supported signal timing must be confirmed for the supplied unit. Do not assume DShot, bidirectional drive, braking modes or compatibility with every programming card. This is not a brushed-motor driver or a bare-motor speed knob.

Connection and installation checks

Identify the battery positive and negative leads before fitting connectors. Check polarity with a meter and insulate every exposed joint. Never rely on reverse-polarity protection: it has not been verified for this exact unit. The three motor-phase leads connect to the three leads of a compatible sensorless brushless motor, not to battery power.

The receiver/control cable carries the throttle signal, ground and the BEC supply connection. Verify its pin order against the receiving device; do not rely on plug orientation alone. Do not join multiple BEC outputs, an external regulator and a receiver battery on the same power rail unless the power system is specifically designed for it.

Safe setup before flight

Remove the propeller or other driven load before initial setup, throttle calibration and direction checks. Secure the motor and keep clear of rotating parts.

Use the correct instructions for the supplied ESC when setting throttle endpoints or programming. Generic beep sequences may not match its firmware.

Check control-signal failsafe and throttle cut before installing a propeller. Disconnect the flight battery before changing wiring or swapping motor leads.

Choose a motor, propeller and battery combination that stays within the ESC rating with operating margin. Check current and temperature under suitable test conditions.

Provide airflow and stop if the motor stalls, shakes, overheats or emits a burnt smell. Zero throttle does not disconnect the battery.

Package includes

1 x SimonK 30A-class brushless ESC. Battery, motor, receiver, connectors and other items in the application photo are not included.

More in ESCs

You might also need