SIM800L V2 5V 2G GSM GPRS UART Module - RS1068/RS4079

SKU RS1068/RS4079

RS1068/RS4079 is a blue SIM800L breakout for microcontroller projects that need GSM text messaging or GPRS data.

₹658.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

SIM800L V2 5V GSM/GPRS development module RS1068/RS4079 is a blue SIM800L breakout for microcontroller projects that need GSM text messaging or GPRS data. A controller sends AT commands over the serial UART and reads the modem's replies. The photographed module has a SIM holder, external antenna connection and a labelled seven-pin power/UART header. This is a 2G GSM/GPRS device, not a 4G/LTE, LTE-M or NB-IoT modem. Its quad-band radio supports GSM 850/900/1800/1900MHz, but operation depends on a compatible SIM, active service and a carrier that still provides suitable 2G coverage at your location. Check those requirements before choosing it for a project. Worldwide operation is not guaranteed. Power and wiring Use regulated 5V at the breakout's labelled 5VIN input and GND. Provide a supply capable of at least 2A bursts, with short, suitable power leads. A weak supply or voltage drop can cause resets during network activity. Do not power the modem from a GPIO or assume a controller board's small regulator can supply it. This 5V breakout input is not the bare SIM800L chip's battery supply. Do not apply 5V directly to bare-module VBAT, and do not apply 12V or 20V to this board's 5VIN pin.

5VIN and GND: main board power.

VDD: UART logic reference on this breakout design, not a substitute for main power.

TXD: modem transmit output, connected to controller receive.

RXD: modem receive input, connected from controller transmit.

RST: reset control; leave inactive when not needed.

Match the supplied PCB labels rather than copying a rotated photo. Verify the board revision's VDD connection and UART voltage compatibility before connecting an Arduino, ESP32 or other controller. Use level conversion where required and share ground. The bare modem's logic limits must not be confused with breakout-level compatibility. Start with simple checks Fit the SIM and antenna with power off. Establish a serial connection and send AT, then confirm an OK response. Check AT+CPIN? for SIM readiness, AT+CSQ for signal information and AT+CREG? for registration. Signal strength alone does not confirm registration. GPRS data also needs the carrier's correct APN and an enabled plan. The pictured PCB is marked V2.2, although this module family is often sold as V2. No micro-USB connector or 3.5mm audio socket is shown. Do not assume those interfaces or a particular firmware feature from another SIM800 board. Package 1 x SIM800L V2 module with antenna and adapter lead as pictured, SKU RS1068/RS4079. SIM card, cellular service, controller and 5V power supply are not included.

More in GSM & GPS Modules

You might also need