Raspberry Pi GPIO Expansion Board with Quick-Connect Terminals - RS182

SKU RS182

Raspberry Pi GPIO Expansion Board with Quick-Connect Terminals The RS182 brings the Raspberry Pi's GPIO header connections out to labelled pin headers and push-button terminals.

₹373.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

Raspberry Pi GPIO Expansion Board with Quick-Connect Terminals

The RS182 brings the Raspberry Pi's GPIO header connections out to labelled pin headers and push-button terminals. It is useful for connecting sensors, switches and other low-voltage project circuits without repeatedly soldering wires. The board groups common interfaces such as UART, SPI and I2C so their connections are easier to find.

This is a connection breakout for the Pi's existing signals, not an extra processor or a substitute for a driver circuit. Repeated terminals for one GPIO share the same signal. Plan connected devices so that two outputs do not drive the same line against each other.

Compatibility and fitting

Listed Raspberry Pi compatibility: B+, 2B, 3B, 3B+ and 4B with the appropriate GPIO header.

Check header alignment, pin 1 orientation, mounting-hole fit and clearance before fitting.

Shut down and disconnect Pi power before installing the board or changing wiring.

Use the supplied mounting hardware where suitable, without allowing metal fasteners to short exposed connections.

Numbering and signal levels

GPIO/BCM numbers are not the same as physical header-pin numbers. For example, GPIO2 is physical pin 3 and GPIO3 is physical pin 5 on the standard 40-pin header. Match the board labels, your software's numbering mode and the peripheral's own pinout before connecting anything.

Raspberry Pi GPIO signals use 3.3V logic. The presence of 5V power terminals on this breakout does not make GPIO inputs 5V-tolerant. Use suitable level conversion for incompatible signals, and a proper driver and supply for motors, relay coils or other loads beyond GPIO capability. Do not connect mains voltage to this board.

Using peripheral interfaces

Enable and configure the required I2C, SPI or serial interface in Raspberry Pi OS before use. Check any pin conflicts with other attached hardware and observe the peripheral's voltage and current requirements. A labelled UART or SPI header alone does not guarantee that every external device is electrically compatible.

Package includes

1 x Raspberry Pi GPIO expansion board and a set of mounting accessories. Raspberry Pi, sensors, power supply and other project hardware are not included.

More in Raspberry Pi HATs

You might also need