About this product
Pro Mini ATmega328P 5V/16MHz Development Board
The RS3816 is a compact Pro Mini-compatible board listed with an ATmega328P microcontroller, 5V operation and a 16MHz clock. It is intended for embedded electronics projects where a full-size USB connector is not needed. The black board has a reset button, labelled connection pads and a separate serial programming header. This is a generic compatible board, not a claim of manufacture by Arduino or SparkFun.
What you need to get started
A compatible external USB-to-TTL serial adapter with suitable 5V logic levels, a data-capable USB cable for that adapter and jumper leads.
A correctly configured Arduino-compatible development environment and a working bootloader, or a suitable ISP programmer if the bootloader needs to be installed.
A stable power supply and any headers or wires soldered for your project. Soldering tools and programming adapter are not included.
There is no onboard USB-to-serial interface. A USB cable cannot connect directly to the bare board. Do not use an RS-232 serial port in place of a TTL serial adapter.
Programming connections
Match labels rather than assuming that two six-pin connectors share the same orientation. Adapter TX connects to board RXI, adapter RX connects to board TXO, and grounds must be common. For automatic reset, use the compatible adapter's DTR or RTS arrangement only as required by the actual board. Check its reset circuitry and pin labels before connecting. Select the matching Pro Mini board, ATmega328P processor and 5V/16MHz configuration in the installed board package; menu wording depends on the IDE and core version.
Power and logic-level checks
VCC is the regulated supply rail. On the listed 5V version, feed VCC from a suitable regulated 5V supply. RAW is a separate input path through the onboard regulator, not another name for VCC. Verify the fitted regulator's allowable input, dropout and heat dissipation before using RAW; this listing does not establish a safe maximum RAW voltage or an available peripheral-current rating for every compatible revision.
Avoid connecting multiple power sources that can feed into one another. Check the adapter's power-output voltage and logic voltage separately. Use level conversion where needed for 3.3V-only devices. Do not assume reverse-polarity, overcurrent or short-circuit protection. Motors, servos and other high-current loads need suitable drivers and their own correctly designed power supply, not direct drive from an I/O pin.
Interfaces and project uses
The ATmega328P platform provides digital I/O, analog inputs, PWM and UART, SPI and I2C interfaces. Available pads and alternate pin functions must be checked against the supplied board and the selected core. It suits small sensor interfaces, embedded controls, learning projects and permanent installations after testing the wiring and firmware. Wi-Fi, Bluetooth and a USB programmer are not built in.
Package contents
1 x Pro Mini-compatible 5V/16MHz development board. Listing photographs show loose pin-header strips; they are not pre-soldered to the board. USB-to-TTL adapter, cable, sensors and power supply are not included.