About this product
Optical encoder disc and sensor kit
RS091 is a compact photoelectric feedback kit for measuring rotation in robot wheels, motor experiments and DIY tachometers. A slotted metal code disc passes through the optical reader's sensing gap. Rotation interrupts the light path and produces electrical pulses that a suitable controller can count.
The listing photos show a thin code disc, a four-wire optical reader and small mounting pieces. This is a component kit, not a motor, a complete enclosed shaft encoder or a plug-in USB measuring instrument. Check the mechanical fit and mounting space before ordering.
Disc and electrical details
Nominal disc specification: 100 lines, approximately 22mm outside diameter, 3.5mm centre hole and 0.3mm thickness.
Listed sensor supply: regulated 5V DC.
Typical wiring: red for supply, black for ground, yellow and blue for the two signal channels.
Two pulse outputs are intended for speed and direction decoding. Confirm wire functions on the supplied sensor before connecting.
Treat the outputs as 5V-class signals. Do not connect them directly to 3.3V-only ESP32, Raspberry Pi or similar GPIO without a suitable level interface and verified input limits. A supplier's mention of a 3.3V version does not confirm that every supplied sensor runs from 3.3V.
Mounting and first test
Secure the disc square to the shaft and align the reader so the slotted track passes through its gap without touching. Keep the thin disc flat and the optical path clean. Provide strain relief for the wires and keep signal wiring away from noisy motor-power leads.
With the motor drive disabled, turn the shaft slowly by hand. Check both outputs using an oscilloscope, logic analyser or compatible controller input. A multimeter's average voltage does not prove that valid pulses are present. Direction sensing requires two valid phase-offset signals; do not infer direction from one working channel.
Counting and RPM
Use a suitable counter or interrupt-based decoder. Counting one edge on one channel differs from counting every edge of both channels. Measure counts over one full revolution using your chosen software; include any gearbox ratio. Calculate RPM by dividing counts x 60 by the product of counts-per-revolution and elapsed seconds. Confirm count direction before enabling closed-loop motor control.
Package
1 x RS091 photoelectric sensor and slotted-disc kit as pictured. Motor, controller, power supply and mounting bracket are not included.