About this product
NE555 adjustable pulse and square-wave generator
NA309 is a compact NE555 pulse signal generator module for electronics experiments, timing demonstrations and controller-input tests. It generates a repeating square or rectangular waveform at the OUT connection. Two onboard trimmers adjust the waveform, and a jumper selects the timing range. The photographs show a red PCB, two blue adjustment trimmers, timing components and a three-pin connection header.
What the module does
Use the output as a test pulse for a compatible counter, microcontroller input or stepper-driver STEP input. This module provides the control signal, not the power needed to run a motor. A stepper motor still needs a suitable driver and separate motor supply. Relays, lamps and other power loads also need an appropriate switching stage.
Timer type: NE555 pulse generator module.
Existing module supply specification: 5V to 15V DC.
Connections: VCC, GND and OUT, identified from the actual PCB labels.
Adjustment: two trimmers and a selectable timing-range jumper.
Output: repeating pulse waveform, not a sine-wave or arbitrary-waveform generator.
Package: one pulse generator module, SKU NA309.
Adjust and measure the waveform
Disconnect power before moving the range jumper or changing wiring. Read the supplied board labels rather than transferring a pin order from another module. Begin with the output disconnected from the receiving circuit. Use an oscilloscope or a suitable frequency meter to check frequency, duty cycle and output voltage.
Frequency and duty cycle can interact on this module: changing one setting may change the other. Adjust gradually and measure again after each change. Component tolerances and the selected range affect the result. This listing does not promise a calibrated frequency span, an exact duty-cycle range or a fixed output-current rating.
Check logic compatibility before connecting
Output voltage depends on the supply and connected load. Do not assume OUT is a regulated 3.3V signal or safe for every microcontroller input. Check the receiving device's permitted high and low levels, input-current needs and maximum voltage. Use suitable level conversion or buffering where needed, with a common ground reference where the interface requires it.
The onboard LED is a visual indication only; it is not a frequency measurement. Verify the signal before relying on it in a project. Controller, motor driver, motor, measuring instrument, power supply and connecting leads are not included.