About this product
Self Lock Relay Cycle Timer Relay Module
6-40 V
9 kinds of function parameters
Accuracy of better than 0.1 seconds
DESCRIPTION
Users can display the buttons and select the following nine kinds of functions in one, you can set and save 9 kinds of function parameters, you can also view the current function parameters, time parameter sets the minimum one second adjustable accuracy of better than 0.1 seconds.
TWO MODULE INTERFACE
Module control side: there are 3-wire interface, all interfaces are terminal, user-friendly.
DC+: DC power supply positive(with 5V, 12V and 24V modules to choose from)
DC-: DC power cathode.
CH1: Hold Input Detection Interface.
Relay outputs: A 3-wire interface, all interfaces are terminals.
NO1: normally open relay interface, the relay becomes vacant before, pull shorting after the COM1.
COM1: Relay Common Interface.
NC1: normally closed relay interface relay shorted before and COM1, pull vacant post.
FUNCTIONS
Function 1: Timing Pick: After power relay delay time T1, T1 in 0 seconds adjustable between -270 hours, give CH1 connector is a high pulse signal(high duration is greater than or equal 20ms, hereinafter the same), repeat the above functions.
Function 2: Timed disconnect: On power relay, time relay off delay time T1, T1 in 0 seconds adjustable between -270 hours, giving a high level pulse signal CH1 connector, repeat the above functions.
Function 3: Loop Timing Mode 1: After power on, to not pull the relay, the delay time T1 after arrival relay; pull the relay off time T2 after arrival, and then repeat the above state, the delay time T1 and T2 in 0 seconds adjustable between -270 hours, giving a high level pulse signal CH1 connector, you can resume these functions.
Function 4: Loop Timing Mode 2: After power, the relay immediately pull, delay time T1 after arrival relay off; off time T2 arrives relay, and then repeat the above state, the delay time T1 and T2 in 0 seconds - adjustable between 270 hours and give CH1 connector is a high pulse signal, these functions can be re-started.
Function 5: Latching relay mode: CH1 connector to relay a high level pulse signal, the relay, to give a high level pulse signal relay disconnected.
PACKAGE INCLUDED
1 x Multifunctional relay module