About this product
MP1584EN Mini Adjustable DC-DC Buck Converter
Fit an adjustable step-down supply into a small project with this MP1584EN-based converter module. Its compact PCB has an onboard inductor, trim potentiometer and clearly marked input/output solder pads. It converts a higher DC input into a lower DC output for suitable embedded circuits and electronics prototypes.
Module details
MP1584EN-family buck-converter circuit.
Listed input range: 4.5-28V DC.
Listed adjustable output range: approximately 0.8-20V, subject to input voltage and required headroom.
Input pads marked IN+ and IN-, output pads marked OUT+ and OUT-.
Onboard trim potentiometer for output-voltage adjustment.
Compact solder-pad format for integration into a larger assembly.
Adjustment and first use
Check polarity, apply a suitable DC input without the load connected, and measure the output with a multimeter while adjusting the potentiometer. Set the voltage before connecting sensitive electronics. The module is step-down only and cannot maintain an output above its input.
The MP1584 is a 3A-class converter IC, but the small module's continuous current depends on input/output voltages, cooling, board layout and component temperature. Start with a modest load and verify stable voltage and acceptable temperature. Do not assume a 3A continuous output or a fixed efficiency for every operating condition.
Integration notes
Insulate the exposed pads and underside from metal surfaces. Use short power connections and suitable wiring, and recheck the output after installation. This module is not galvanically isolated and is not a constant-current charger or direct mains supply. Add any protection, filtering and enclosure required by the finished project.
Package contents
1 x MP1584EN mini adjustable buck converter module
Reference media