About this product
Mornsun LMF1000-20B48 Power Supply
The Mornsun LMF1000-20B48 is an enclosed AC-DC switching power supply providing a regulated 48V DC output at up to 21A, with a rated output power of 1008W. It accepts the AC or DC input ranges listed below and is designed for integration into finished equipment.
This 48V variant delivers 1008W at 21A on the main output, plus a separate 10W auxiliary 5V/2A rail. Built-in active PFC keeps the power factor high and reduces harmonic load on the mains supply. A built-in DC fan provides forced-air cooling; keep the vents unobstructed and expect audible fan noise in quiet environments. Important: before powering on, the PS_ON jumper between Pin6 (PS_ON) and Pin7 (GND) on the control terminal must be shorted or the unit gives no output; see the datasheet note.
Key Features
Adjustable DC output (48-56V) for compatible equipment and control circuits.
94% typical efficiency at 230VAC.
4000VAC input-to-output isolation test rating.
Protection against short-circuit, over-current and over-voltage faults.
Enclosed metal chassis with screw-terminal connections.
Built-in DC fan (forced air cooling). Allow suitable airflow and installation clearance.
Technical Specifications
Model
LMF1000-20B48
Nominal output
48V DC / 21A
Rated output power
1008W
Output adjustment
48-56V DC
AC input
90-264VAC
DC input
120-370VDC
Typical efficiency at 230VAC
94%
Maximum capacitive load
4000 (main) / 1000 (aux)µF
Input-output isolation test
4000VAC
Operating temperature
-40°C to +70°C, with derating above +50°C
Dimensions
190 × 127 × 40.5mm
Cooling
Built-in DC fan (forced air cooling)
Selection and Installation
Match the output rails to your load, and allow for its continuous current and start-up demand. Follow the manufacturer's derating curves: the maximum output is not available at every input voltage or ambient temperature. Adjusting the output voltage does not increase the permitted output power or current.
This is a component power supply, not a consumer plug-in adapter. Mains wiring should be carried out by a qualified person in a suitable protective enclosure. Disconnect input power before connecting wires, follow the marked terminal assignments and protective-earth requirements, and keep ventilation paths clear. The isolation figure is a test rating, not a continuous operating voltage.
Package contents: 1 × Mornsun LMF1000-20B48 power supply.
Manufacturer datasheet: specifications, dimensions and derating curves. Product images are for reference; follow the supplied unit's markings and documentation.
Adjustable DC output (48-56V) for compatible equipment and control circuits.
94% typical efficiency at 230VAC.
4000VAC input-to-output isolation test rating.
Protection against short-circuit, over-current and over-voltage faults.
Enclosed metal chassis with screw-terminal connections.
Built-in DC fan (forced air cooling). Allow suitable airflow and installation clearance.