About this product
MG995 Continuous Rotation Servo Motor
The MG995 360 degree servo is intended for continuous rotary motion in robot drives, small conveyors and other hobby mechanisms. Unlike a positional servo, this version uses its control pulse to set rotation direction and speed. It does not move to a requested 0-360 degree angle or report its shaft position.
Product overview
Model: MG995 continuous rotation variant.
Metal gear drive in a standard-size servo housing.
Three-wire connection for power, ground and control signal.
Suitable for controller-generated servo pulses, including Arduino-based projects.
The gallery shows the MG995-labelled housing, output shaft, cable and accessory layout. Photographs cannot verify internal gearing or performance under load. Exact torque, speed, current and supply limits vary between MG995 versions, so check the supplied unit's specification before sizing a mechanism or selecting its power supply. This is not a precision positioning actuator.
How continuous control works
Begin with a pulse near 1500 microseconds, which is the typical neutral or stop region. Pulses shorter or longer than neutral request rotation in opposite directions; the distance from neutral changes speed. The exact stop point and useful endpoints need to be checked on the actual servo. A small software trim may be needed if the shaft creeps at the nominal neutral setting.
Test with wheels lifted or the mechanism disconnected. Do not interpret an angle-style software command as a guaranteed physical angle. Timed rotation is load-dependent and is not a substitute for an encoder when a project needs a measured turn count or position.
Power and wiring checks
Use a regulated supply suited to the servo and its startup or stall current, not a controller GPIO pin. Join the controller ground to the servo supply ground so the signal has a common reference. Check the actual lead functions and polarity before connecting; do not rely only on wire colours. Keep the servo power rail away from logic inputs and disconnect power before fitting a horn or changing wires.
Package contents
1 x MG995 continuous rotation servo motor. Accessory photographs illustrate horn and mounting-part styles; the supplied assortment may vary. Controller, external supply and robot chassis are not included. SKU: RS2286.