About this product
Sensor connection shield for Arduino Mega
RC042 is a Mega Sensor Shield V2.0 expansion board for organising sensor, servo and peripheral wiring on an Arduino Mega 1280 or Mega 2560-style board. It brings the controller's connections to labelled headers, reducing the need for a separate breadboard in compatible projects. This is a passive connection shield, not a standalone microcontroller or a motor driver.
Connections on the photographed board
Three-row G, V and S groups alongside the digital and analogue pin labels.
Digital pin numbering through 53 and analogue inputs A0 to A15.
Dedicated labelled headers for Bluetooth, SD card, APC220 and URF01 connections.
Additional power, serial and I2C pin labels, a reset button and an external screw-terminal power connection.
A PWR_SEL jumper associated with the power-rail arrangement.
G identifies ground, V identifies the relevant supply rail and S identifies the controller signal. Check the printed labels on both the shield and your module before connecting a cable. Do not assume every connector uses the same orientation or that wire colours establish its pinout.
Compatibility and software
The Mega-sized footprint is intended for compatible Mega boards. It is not a drop-in Uno sensor shield, despite some generic titles describing it that way. Check header alignment and clearance before fitting it, with all power disconnected. Do not force pins into a mismatched header.
The shield does not add processing power, extra independent I/O or automatic peripheral detection. Your sketch still needs the correct pin numbers, communication settings and any library required by the attached device. A labelled Bluetooth or SD header does not include that module or guarantee voltage compatibility with every version.
Power and first-use checks
Verify the PWR_SEL jumper and rail connections before using external power. These boards do not provide a general-purpose regulator that makes arbitrary input voltages safe for attached sensors. Never apply 9V or 12V to a 5V sensor rail. Do not connect competing supplies together through a fitted jumper.
Test one compatible sensor first. For servos or other higher-current loads, use a suitable regulated supply, check rail isolation and provide a common signal ground where required. Do not power multiple servos from a controller pin or assume the shield is a high-current distribution board.
Includes one Mega Sensor Shield V2.0. Arduino Mega, sensors, servos, wireless modules, SD module, power supply and cables are not included. SKU: RC042.