About this product
Arduino uno with USB Cable – 1
Jumper wire male to male – 40 pieces
Jumper wires Male to Female – 10 pieces
Breadboard 830 points – 1
10k Potentiometer – 1
16*2 LCD Display – 1
HC Sr-04 Ultrasonic sensor- 1
Single Stand wire 1mt -1
HARDWARE REQUIRED
Arduino uno with USB Cable – 1
Jumper wire male to male – 40 pieces
Jumper wires Male to Female – 10 pieces
Breadboard 830 points – 1
10k Potentiometer – 1
16*2 LCD Display – 1
HC Sr-04 Ultrasonic sensor- 1
Single Stand wire 1mt -1
SOFTWARE REQUIRED
Arduino IDE 1.8.5 (Programmable Platform for Arduino Boards)
Click to download the software: https://www.arduino.cc/en/Main/Software
PIN DESCRIPTION
HC SR04 ULTRASONIC SENSOR
16*2 LCD DISPLAY
10K POTENTIOMETER
CIRCUIT DESCRIPTION
Connection for LCD 16*2 Display with Arduino uno
LCD 16 * 2
Arduino
VSS
GND
VCC
5V
RS
PIN 11
R/W
PIN 10
E
PIN 9
DB4
PIN 2
DB5
PIN 3
DB6
PIN 4
PIN 5
LED+ (A)
5V
LED- (K)
GND
Connection for HC SR-04 Ultrasonic Sensor with Arduino UNO
Ultrasonic Sensor
Arduino
VCC
5V
GND
GND
ECHO
Pin 12
TRIG
Pin 13
Connection for the potentiometer with LCD 16*2 and Breadboard
Potentiometer
LCD
Breadboard
Pin 1 (left)
5v
Pin 2(mid)
Pin 3
Pin 3 (right)
Gnd
CODE
Before coding, you have to install new ping library
https://drive.google.com/open?id=11gy_6v61-Eq0sAz8RJF_sn5Tl0g7z8Cj
Sketch > Include library > Manage Library > Search NEWPING library > download it
Or you download NewPing Library from other site.
https://drive.google.com/open?id=107vaWoBXZ8t6xtLExf7GQPetTcTP6glO
RUN SKETCH AND VERIFY OUTPUT
After compiling, uploading and running it
As far as the object goes far from the ultra-sonic sensor, Distance will be vary and measured distance will be show in LCD
in the Serial Monitor (Tools -> Serial Monitor or Ctrl + Shift + M) the sensor was sending correct data
Note: Must Set the baud Rate to 115200
Ping: 36 cm or the value shown in the serial monitor depends on the object distance from the ultra-sonic sensor.