Measure the current Value using ACS712 Current Sensor- 30A interfacing with Arduino Uno - KT832

SKU KT832

Output voltage proportional to AC or DC currents Device bandwidth is set via the new FILTER pin Jumper wires (Male to Female AND male to male) - 40 pieces each Arduino IDE (

₹1545.00

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

Output voltage proportional to AC or DC currents

Factory-trimmed for accuracy

Extremely stable output offset voltage

Ratiometric output from supply voltage

Low-noise analog signal path

Device bandwidth is set via the new FILTER pin

Small footprint, low-profile SOIC8 package

HARDWARE REQUIRED

Arduino Uno with USB cable - 1

Current Sensor ACS712 30A- 1

Jumper wires (Male to Female AND male to male) - 40 pieces each

SOFTWARE REQUIRED

Arduino IDE ( programmable software for Arduino boards )

You can download the software from this link : https://www.arduino.cc/en/Main/Software

PIN DESCRIPTION (current sensor )

CIRCUIT DESCRIPTION

CODE CLICK TO SEE THE CODE: https://docs.google.com/document/d/e/2PACX-1vSXBFMnftavXwlNmFD0vPf5PrqFIIak8ELe57IzknSM9CO5Jvh0ypIxLxYQQ0IXwaQagCG6Xq9jz4Yl/pub

OUTPUT Just follow the given steps and measure the current value.

FREQUENTLY ASKED QUESTION

Q. What voltage i need to supply to module to power it on?A. Give regulated +5V to module at its VCC connector.

Q. What is output voltage without any load?A. It is VCC/2 so it means around 2.5V

Q. What happens to output voltage if i connect a DC load current?A. When DC load takes current the output voltage will deviate from 2.5V to either 0V or 5V depending on polarity of sensing load.

Q. Does DC load and AC load has same type of output?A. No. With DC load you can check simply with multimeter, But in case of AC load its totally different. Your multimeter will show same 2.5V output whatever load you put on AC because what happens here is when positive AC phase is going on the output voltage increased from 2.5V and during negative phase the output voltage decreases from 2.5V so your multimeter will average that and show you same voltage.

More in Arduino Boards

You might also need