About this product
Kit Includes
Node MCU (esp82 66-12e v1.0) Wi-Fi Board -1
NodeMcu USB cable - 1
DHT11 Module - 1
Jumper Wires (male to male) – 20 pcs each
830 pt. breadboard - 1
Introduction
In this project, we have used to design an IOT based temperature and Humidity using Node MCU and DHT11 by interfacing with the BLYNK application.
HARDWARE REQUIRED
Node MCU (esp82 66-12e v1.0) Wi-Fi Board -1
NodeMcu USB cable - 1
DHT11 Module - 1
Jumper Wires (male to male) – 20 pcs each
830 pt. breadboard - 1
SOFTWARE REQUIRED
Arduino IDE 1.8.10 (programmable platform for Arduino)
Click To Download: https://www.arduino.cc/en/Main/Software
SPECIFICATIONS
NodeMCU ESP8266 CP2102 NodeMCU WIFI Serial Wireless Module
ESP8266 CP2102 NodeMCU LUA ESP-12E WIFI Serial Wireless Module
Built-in Micro-USB, with flash and reset switches, easy to program
Full I/O port and Wireless 802.11 supported, direct download no need to reset
Arduino compatible works great with the latest Arduino IDE/Mongoose IoT/Micro python
DHT11 Module
Operating Voltage: 3.5V to 5.5V
Operating current: 0.3mA (measuring) 60uA (standby)
Output: Serial data
Temperature Range: 0°C to 50°C
Humidity Range: 20% to 90%
Resolution: Temperature and Humidity both are 16-bit
Accuracy: ±1°C and ±1%
1
Vcc
Power supply 3.5V to 5.5V
2
Data
Outputs both Temperature and Humidity through serial Data
3
Ground
Connected to the ground of the circuit
APPLICATION REQUIRED
BLYNK
Download from Google play store and Apple Store
CIRCUIT CONNECTION
Connect DHT11 “S” pin to node MCU pin D4
Connect DHT11 “V” pin to node MCU pin 3v3.
Connect DHT11 ground to node MCU ground.
CODE
Click to see the code
https://drive.google.com/open?id=1fFfMQ8t0hYgksC7A3935421xTWG6EAMq
Must mention your correct Wi-Fi ID and Password in the code
WORKING AND OUTPUT
Welcome to the Node MCU Based project.
To connect with Blynk Application. First, you need to create a new project An AUTH token will be sent to your registered Email ID which you need to note down. You need to insert the key in the given code.
Open the Widget Box and select the Labeled value widget option from the Dropdown list
Click on the plus icon and select Labelled value for temperature.
Define the pins in our case V5.
Change the min to 0 Max to 50.
Now again click the icon and select Labelled value for Humidity and change the max 100%. And define the pin in our case V6.
Now click on the play button and you will get temperature and humidity.
The output will shown as Humidity and Temperature in the figure below.
Click to watch the tutorial
For more tutorials subscribe our channel REES52 on YouTube
https://www.youtube.com/channel/UCKuJ1KCjJGat7PrdAcWtu5g