MC-38 Magnetic Door Window Contact Reed Switch - NB033

SKU NB033

MC-38 Wired Magnetic Door and Window Contact The NB033 MC-38 is a two-part magnetic contact for door, window and cabinet monitoring projects.

₹58.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

MC-38 Wired Magnetic Door and Window Contact

The NB033 MC-38 is a two-part magnetic contact for door, window and cabinet monitoring projects. The wired section contains a reed switch, while the separate magnet moves with the door or window. A compatible controller reads the contact state and decides what to do when the two parts move apart.

How to use it

Mount the wired contact and magnet on the fixed and moving surfaces, aligned so the switch changes state reliably.

Connect the two-wire contact to a compatible low-voltage alarm input or microcontroller circuit.

For an Arduino example, connect one wire to D2 and the other to GND, then configure D2 as INPUT_PULLUP.

With this wiring, a closed electrical contact reads LOW and an open electrical contact reads HIGH. Test both physical door positions before assigning open/closed alarm logic.

Avoid D13 on boards where the built-in LED loads the input. The passive contact does not supply its own signal voltage. It needs an external pull-up or a controller's internal pull-up. The two switch wires have no polarity in this example. Do not treat wire colour as a power-supply pinout.

What to check

Confirm the contact behavior with a continuity meter before fitting. Test the installed alignment and gap, especially on metal frames. Operating distance depends on the magnet, mounting surface and alignment, so do not rely on a universal sensing gap.

Model MC-38

Product type Wired magnetic reed contact and separate magnet

Interface Two-wire passive switch contact

Use Door, window and cabinet status input

SKU NB033

Safety and compatibility

Use as a low-voltage signal contact. Do not connect it directly to mains power, a motor, lamp or other high-current load. Verify the exact contact ratings for your installation. This is a sensor pair, not a complete alarm: a controller and any buzzer, notification device or power supply are separate.

Package includes 1 x MC-38 wired contact and matching magnet. Arduino board, door and other hardware in the example-use guide are not included.

More in Hall Sensors

You might also need