Make a Traffic Light System using Arduino Uno - KT946

SKU KT946

In this project we are making a Traffic Light System which consists of the LEDs for making a simulation of traffic lights, the blinking time of each LED should be the same with

₹1198.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

Kit includes

Arduino UNO with USB cable – 1

400 point breadboard – 1

Red led– 2 Pieces

Yellow Led - 2 Pieces

green led - 2 Pieces

Resistor 220 ohm – 5

Jumper wires (male to male) – 20 pieces

Introduction In this project we are making a Traffic Light System which consists of the LEDs for making a simulation of traffic lights, the blinking time of each LED should be the same with those in the traffic lights system.

HARDWARE REQUIRED

Arduino uno with Usb cable – 1

400 point breadboard – 1

Red led– 2 Pieces

Yellow Led - 2 Pieces

green led - 2 Pieces

Resistor 220 ohm – 5

Jumper wires (male to male) – 20 pieces

SOFTWARE REQUIRED

Arduino IDE (Programmable Platform for Arduino) CLICK TO DOWNLOAD: https://www.arduino.cc/en/Main/Software

PIN DESCRIPTION LED

CIRCUIT DIAGRAM

connect all the negative of the leds then connect to the ground pin of Arduino UNO

Positive of green Led to Arduino’s digital pin 8 via 220-ohm resistor adding on the positive terminal of led.

Positive of Yellow Led to Arduino’s digital pin 9 via 220-ohm resistor adding on the positive terminal of led.

Positive of Red Led to Arduino’s digital pin 10 via 220-ohm resistor adding on the positive terminal of led.

CODE Click to see the code or copy the link: https://docs.google.com/document/d/e/2PACX-1vTD0ysLgo207_IH-FD7uz6hw1hhRGa79ofD-Iq4oWLJvVdOV_78QCY9IVDfSamcC_D0VOZD0n_ii2Ly/pub

WORKING Welcome to the Arduino Based Project which consists of the LEDs for making a simulation of traffic lights, the blinking time of each LED should be the same with those in the traffic lights system. In the program, we use Arduino delay () function to control delay time. So, when the uploading process is completed, we can see the traffic lights of our own design. The green light will be on for 5 seconds, and then off., followed by the yellow light blinking for 3 times, and then the red light on for 5 seconds, forming a cycle. And the Cycle repeats.

More in Arduino Boards

You might also need