About this product
INTRODUCTION
In today’s tutorial, we will make a Snake maze game using a 16*2 LCD and PS2 Joystick module with Arduino Nano. This is one of the most popular games of our childhood. This project is based on a 16*2 LCD, which gives a little room for a snake.
HARDWARE REQUIRED
Arduino Nano-1pc
USB Cable - 1pc
LCD 16*2 Display - 1pc (yellow)
Joystick Module - 1pc
Jumper Wire (Male to Male) - 40pcs
Jumper Wire (Male to Female) - 40pcs
Potentiometer 10k - 1pc
Breadboard 400 Points - 1pc
SOFTWARE REQUIRED
Arduino IDE 1.8.10 (programmable platform for Arduino)
Click here to download the software
SPECIFICATIONS
Joystick Module:
5V/3.3V Compatible
Analog Output
Arduino Nano:
DC Current Per I/O Pin: 40 mA
Digital I/O Pins: 22
Operating Voltage: 5VDC
16*2 LCD Display:
5V power supply ( Also available for +3V)
Negative voltage optional for +3V power supply
CIRCUIT CONNECTION
Arduino Nano to Joystick:
Arduino Nano
Joystick
A0
VRx
A1
VRy
A2
SW
5v
5v
Gnd
Gnd
Arduino Nano to LCD:
Arduino Nano
LCD
Gnd
Vss
5v
Vdd
Middle pin of 10k potentiometer (Connect First pin of pot with Gnd and 3rd pin to VCC)
V0
Digital Pin 12
RS
GND
R/W
Digital Pin 11
E
Digital Pin 5
DB4
Digital Pin 4
DB5
Digital Pin 3
DB6
Digital Pin 2
DB7
5v
LED+
GND
LED-
To connect multiple GND and 5V wires soldering may be required or you can use a breadboard.
CODE
Run the code given below and play the game.
Click to open in Drive👈
WORKING AND OUTPUT
Welcome to the Arduino-based project.
After uploading the code, you will see a Level 1 Python Content. Now start to play. It has 4 levels in the code you can change the level of the game, and if the tail and the mouth of the snake touch, then the game will be over, but if you complete the level, then you will be automatically redirected to the next level.
DOCUMENTS
KT877 - Click to open 👈