About this product
LM2596S Adjustable Buck Converter with Digital Voltmeter
Reduce a DC supply to a lower adjustable voltage with this LM2596S-based converter. This is the version with a built-in LED voltmeter display, push buttons, screw terminals and an adjustment potentiometer. The display helps with setup and monitoring, while the buck-converter circuit supplies a lower DC output for suitable electronics projects.
Key features
LM2596S-family adjustable step-down conversion.
Built-in digital voltage display with input/output measurement selection.
Screw terminals for input and output connections.
Onboard output-adjustment potentiometer.
Nominal adjustable output range: 1.25-37V, limited by the available input voltage and operating headroom.
3A-class regulator design; usable continuous current depends on conversion ratio, cooling and component temperature.
Set up before connecting your load
Check input polarity and confirm the input voltage is within the supplied board's limits. Apply power without the load, measure the output with a multimeter and adjust the potentiometer to the required voltage. Confirm the display is showing the intended input or output reading before relying on it. The onboard display is convenient but is not a substitute for a calibrated meter.
A buck converter cannot raise voltage: the input must remain above the required output, with enough headroom for regulation. Do not treat the advertised maximum current as an unconditional continuous rating. Test under the intended load and provide additional cooling when needed.
Application notes
Suitable for low-voltage DC prototyping, sensor supplies and other loads within its limits. It is not an isolated supply, a constant-current LED driver or a complete battery charger. Do not connect it directly to mains electricity. Avoid reverse polarity, short circuits and power-source conflicts.
Package contents
1 x LM2596S adjustable buck converter module with digital voltmeter display
LM2596S-family adjustable step-down conversion.
Built-in digital voltage display with input/output measurement selection.
Screw terminals for input and output connections.
Onboard output-adjustment potentiometer.
Nominal adjustable output range: 1.25-37V, limited by the available input voltage and operating headroom.
3A-class regulator design; usable continuous current depends on conversion ratio, cooling and component temperature.