About this product
L293D dual H-bridge motor driver board for small motor projects
RS5994 is an L293D-based motor driver module with a socketed driver IC, screw-terminal motor connections, control headers and a power indicator. It is for low-current DC motor experiments and educational robotics where the motor, supply and driver limits are checked before use. The product photos show a compact green PCB, not an Arduino-format stackable motor shield.
What four channels means
The L293D contains four half-H driver outputs. Pairing two outputs makes one full H-bridge for a reversible DC motor, so the normal bidirectional arrangement is two DC motors, or one small bipolar stepper using both output pairs. Four output channels do not mean four independently reversible DC motors.
Driver type: L293D quadruple half-H / dual H-bridge.
Motor connection: two screw-terminal output pairs.
Control: logic inputs; speed control requires suitable PWM and board connections.
Separate logic and motor-supply connections.
Package: 1 x L293D motor driver module, SKU RS5994.
Current and supply limits
The TI L293D IC specification describes up to 600mA per output, subject to operating conditions and heat dissipation. Its 1.2A peak rating is non-repetitive for no more than 100 microseconds, not a continuous motor rating. Allow margin for startup and stall current. Driver voltage drop reduces the voltage reaching the motor and creates heat.
The IC's broad supply range is not a verified voltage rating for this complete module. Photos show separate +9V, GND and +5V supply labels. Confirm the supplied PCB markings, component ratings and wiring before applying power. Never connect the motor supply to the logic rail or assume a regulator is present.
Connection and first run
With power off, identify the control pins, enable connections and output pairs from the actual board. Use a suitable motor supply and the correct shared ground reference. Match the logic interface to the controller; do not assume every header exposes the IC pins in datasheet order.
Start unloaded at a safe current limit, test one motor at a time and watch for heating. Disconnect power before changing wiring. Internal L293D clamp diodes help with inductive transients but do not make the board immune to overcurrent or wiring errors. This is not a current-regulated microstepping driver. Motors, controller, wires and supply are not included.