KY-039 Finger Heartbeat Sensor Module - AB019

SKU AB019

KY-039 style finger heartbeat sensor for learning AB019 is a simple optical pulse-sensing module for Arduino experiments and classroom signal-processing projects.

₹28.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

KY-039 style finger heartbeat sensor for learning AB019 is a simple optical pulse-sensing module for Arduino experiments and classroom signal-processing projects. An infrared LED and a light-sensitive receiver sit on a small board with a three-pin header. With a fingertip in the optical path, small changes in transmitted light can create a varying analogue signal. The module does not directly output a finished beats-per-minute value. What is included

1 x finger heartbeat detection sensor module, SKU AB019.

Infrared emitter and optical receiver on a compact PCB.

Three connections: signal, supply and ground.

Existing listed working supply: 5V DC.

This is an educational electronics module, not a medical device. It is not a pulse oximeter and does not measure blood oxygen saturation. Do not use its readings for diagnosis, treatment or other health decisions. Basic Arduino Uno connection Switch power off before wiring. Read the actual PCB labels: S is the analogue signal, + is supply and - is ground. For a 5V Arduino Uno setup, connect supply to regulated 5V, ground to GND and S to an analogue input such as A0. Confirm the pin order on the supplied module rather than copying a photo's orientation. Start by plotting raw analogue readings in the Arduino Serial Plotter. The ADC number is a light-level reading, not BPM. Detecting beats needs software filtering, sensible peak detection and timing between valid pulses. A single fixed threshold may fail as finger placement or room lighting changes. Get a steadier signal Rest the fingertip gently in the path between the optical parts. Avoid squeezing or bending the components. Support the hand, keep the board still and shade it from strong room light or sunlight. Motion and contact pressure can change the reading more than the pulse itself. Allow the signal to settle and check that a repeatable waveform is present before testing a rate algorithm. Other controllers Check both supply and ADC voltage limits before using an ESP32 or another 3.3V controller. A module powered at 5V can produce an unsafe voltage for a lower-voltage input, so use a suitable analogue interface. Raspberry Pi single-board computers need an external ADC or a separate controller to read this analogue signal; it is not a direct digital GPIO sensor. Controller, wires and ADC are not included.

More in Sensor Modules

You might also need