KY-036 Metal Touch Sensor Module Analog Digital Output - AB009

SKU AB009

KY-036 metal touch sensor module with analog and digital outputs AB009 is a KY-036-style metal touch sensor board for Arduino learning projects and low-voltage input experiments.

₹43.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

KY-036 metal touch sensor module with analog and digital outputs AB009 is a KY-036-style metal touch sensor board for Arduino learning projects and low-voltage input experiments. Touching the exposed metal sensing lead changes the signal presented to the onboard comparator circuit. The photographed red PCB has a blue adjustment trimmer, indicator LEDs and a four-pin header labelled A0, G, + and D0. Board features

Metal touch sensing element and LM393 comparator circuit.

Blue trimmer for adjusting the digital switching threshold.

D0: digital threshold output.

A0: analog signal output for observation with a compatible ADC.

G: ground; +: supply input.

Existing module supply specification: 5V DC.

Package: 1 x metal touch sensor module, SKU AB009.

This is a four-connection board, not a three-pin-only sensor. A0 and D0 have different purposes: the analog pin can be observed during experiments, while D0 changes between logic states around the adjusted threshold. Analog behaviour varies with the board, adjustment and environment. It is not a calibrated measurement of pressure, distance or touch force. Example connection to an Arduino Uno Disconnect power before wiring. Read the labels on the supplied PCB rather than assuming a pin order from a rotated photograph. For a 5V Uno example, connect + to 5V, G to GND and D0 to digital pin 8. A0 may optionally connect to the Uno analog input A0. Set pin 8 as an input and print its state to the Serial Monitor, checking both untouched and touched conditions. Adjust the blue trimmer in small steps and repeat the test. Do not force the adjustment screw. Establish the actual touched logic state in your program instead of assuming every board is active-high or active-low. For a toggle or counter, use suitable debounce and state-change handling so a held touch is not counted repeatedly. Compatibility and use limits Before using a 3.3V-only controller, verify the module supply and both output voltage levels; use a suitable interface where needed. Do not feed a 5V signal directly into an input that cannot tolerate it. Outputs are controller signals, not power outputs for lamps, motors or relay coils. Use only a safe isolated low-voltage circuit when touching the exposed sensing lead. Keep the PCB dry. This is an educational module, not a certified safety switch, industrial interlock, touchscreen or waterproof touch panel. Controller, jumper wires, external loads and power supply are not included.

More in Touch Sensors

You might also need