About this product
HC-SR505 Mini PIR Motion Sensor Module
Add a compact motion input to an electronics project with the HC-SR505 mini passive infrared sensor. A small lens and narrow PCB make the module useful where a larger motion sensor would be difficult to fit. The output changes to a digital high signal when motion is detected, allowing a controller to decide what happens next.
Key specifications
Supply range: 4.5-20V DC.
Digital output: approximately 3.3V high and 0V low.
Quiescent current: less than 60 microamps.
Repeatable triggering, with nominal output delay of about 8 seconds, tolerance +/-30%.
Nominal sensing distance: approximately 3 metres.
Detection cone: less than 100 degrees.
PCB dimensions: approximately 10 x 23mm.
These are nominal HC-SR505 module specifications. Detection depends on movement, mounting position and the surrounding conditions; the stated distance is not a guaranteed coverage boundary.
Connection and first test
Identify supply positive, ground and OUT from the markings on the actual board before connecting power. Do not infer physical header order from a different PIR module. Connect OUT to a suitable digital input on the controller and share a ground reference. The module supply range and the output logic voltage are different specifications.
Allow the sensor to settle after power-up, then move across its detection area while monitoring the input. Repeated movement can keep the output high by retriggering the delay. There are no user adjustment knobs on the board shown in the photos, so do not expect the sensitivity and delay controls found on larger PIR modules.
Project uses and limits
Use it as an input for motion-activated lighting prototypes, interactive displays or simple notification projects. OUT is a signal, not a power output for a lamp, motor or relay coil. Use a suitable driver for a load. This module detects motion, not distance, and should not be relied on to prove a room is unoccupied or as a complete safety or security system.
Package contents
1 x HC-SR505 mini PIR motion sensor module. Controller, power supply, wires and loads are not included. SKU: ML020.
Project demonstration