About this product
GY-906 BCC non-contact infrared temperature module
RS1196 is a GY-906 breakout listed with the MLX90614ESF-BCC infrared temperature sensor. It reads thermal radiation from the surface in front of the sensor and returns digital object-temperature and sensor-temperature readings. Use it for electronics experiments, non-contact surface monitoring and data-logging prototypes, rather than treating it as an analogue temperature probe.
The BCC sensor variant has thermal-gradient compensation and a nominal 35-degree field of view. The target must fill that sensing area; a small object against a different-temperature background can produce a mixed reading. There is no laser aiming spot. Check the supplied sensor marking when a particular variant is required.
Connections and controller setup
VIN: breakout supply input.
GND: common ground with the controller.
SCL: serial clock.
SDA: serial data.
Read the PCB labels before wiring, especially when viewing the underside. The BCC sensor itself is a 3V-family device, specified for 2.6-3.6V at its supply pin. A breakout's VIN rating depends on its regulator circuit. Verify the supplied board's regulator and SDA/SCL pull-up voltage before applying power or connecting GPIO; a regulator alone does not establish logic-level conversion. Do not apply 5V directly to the bare BCC sensor or assume every GY-906 board is interchangeable.
Use an MLX90614-compatible SMBus/I2C library. The usual factory address is 0x5A, and the bus clock should not exceed 100kHz. Arduino Uno uses A4 for SDA and A5 for SCL; other controllers have different pins. Use suitable bidirectional level translation where controller and bus voltage requirements differ. Check communication errors before accepting a temperature reading.
Getting useful measurements
Keep the sensor thermally stable and away from hot electronics, strong airflow and abrupt temperature changes. Gradient compensation reduces some errors but does not remove every environmental effect. Surface emissivity and reflected heat matter, especially on shiny metal. Compare readings against a suitable reference under controlled conditions before relying on a prototype.
Digital resolution is not guaranteed measurement accuracy. The BCC designation does not make this module a medical-grade thermometer. Do not use it for diagnosis, fever screening or a safety-critical thermal cutoff. Keep the exposed PCB dry and protect the optical window from dirt and handling.
Package
1 x GY-906 BCC temperature sensor module, SKU RS1196, with header as pictured. Controller, connecting leads and power supply are not included.