About this product
Description:
A new generation GPS NEO-M8N, with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy, supports GPS/QZSS L1 C/A, GLONASS L10F, B1 protocol, and mode or more. Using 32-bit processor, compatible with V1 & V2 flight controller, incomparably superior to 8-bit processor.
Coming with a soft silicone gel cable of 30cm. For softness, black rubber was wrapped on a surface. (Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok), Metal foil labels have been mounted on the bottom of GPS to reduce signal interference from other electronic types of equipment.
Specifications:
Item Type: GPS Module
Model: Ublox NEO 7M
Receiver Type: x
Receiver frequency: L1 [1575.42MHz]
Input Voltage (V): 3.5 to 5.5
Main Chip: U-BLOX NEO-7M
Position Accuracy (Meter): 2, 2.5
Acceleration (g): <4
Navigation Update Rate: 5Hz
Operating Temperature (°C): -24 to 84
Tracking Sensitivity (dBm): -161 dBm
Co-Ordinate System: WGS-84
Capture Time: 0.1s Average
Avg Cold Start Time (s): 38
Warm Start Time (s): 35
Boot Time: 1S
Maximum Altitude (m): 18000
Maximum Speed: 515 m/s
Features:
Locate performance
These are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play.
Super Bright LED
Backplane with Standard Mk style mounting holes 45mm X 45mm
38400 bps (Default) Changed to 115200bps!
Output GGA, GSA, and RMC frames
1Hz (Default) Changed to 5Hz!
Permanent Configuration Retention
compass on board
6 pin connector for EZ connects to MEGA BLACK
4 pin connector for only GPS use
4-pin connector for compass only use
Can use both 4 pins at once
Package Included:
1 x FPV NEO-M8N GPS amp Compass Support DJI Naza M V1 and V2 Lite Flight Controller
Locate performance
These are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play.
Super Bright LED
Backplane with Standard Mk style mounting holes 45mm X 45mm
38400 bps (Default) Changed to 115200bps!
Output GGA, GSA, and RMC frames
1Hz (Default) Changed to 5Hz!
Permanent Configuration Retention
compass on board
6 pin connector for EZ connects to MEGA BLACK
4 pin connector for only GPS use
4-pin connector for compass only use
Can use both 4 pins at once