About this product
This burning fixture is a production programming and test jig for ESP8266 Wroom modules such as ESP-12E, ESP-12F, ESP-12S, ESP-07 and ESP-07S. Drop the module into the solderless pin fixture, press it down, and flash firmware over the onboard CP2104 USB-UART bridge - no soldering and no external serial adapter needed.
All module pins break out to labeled headers, so the same jig works as a minimum-system development board for testing firmware before the module goes onto your product PCB. The onboard auto-program circuit drives GPIO0 and EN through the serial DTR and RTS lines, so flashing from the Arduino IDE, ESP-IDF or esptool is one click, with dedicated RST and PROG buttons for manual control.
Supports: ESP-12E / 12F / 12S, ESP-07 / 07S and other ESP8266 Wroom modules
USB-UART: CP2104 with micro USB port
Auto reset and download circuit (DTR / RTS), plus RST and PROG buttons
All GPIO, ADC, EN and power pins broken out to 2.54 mm headers
Board size: 47 x 47 mm
Solderless fixture - module snaps in and out for mass programming