DS18B20 1-Wire Digital Temperature Sensor Module - AB032

SKU AB032

DS18B20 digital temperature module for controller projects AB032 is a three-pin DS18B20 temperature sensor module for Arduino experiments, dry indoor monitoring and data-logging

₹180.00

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

DS18B20 digital temperature module for controller projects AB032 is a three-pin DS18B20 temperature sensor module for Arduino experiments, dry indoor monitoring and data-logging projects. It sends temperature readings digitally over a 1-Wire data connection, rather than producing an analogue voltage. The photographed board has a through-hole sensor, supporting components and a header labelled VCC, DQ and GND. Sensor features and measurement limits

DS18B20 digital temperature-sensing interface.

Configurable 9-bit to 12-bit temperature resolution.

DS18B20 IC measurement range: -55 to +125 degrees C.

DS18B20 IC accuracy specification: +/-0.5 degrees C from -10 to +85 degrees C.

Three labelled module connections: VCC, DQ and GND.

Existing module supply specification: 5V DC.

The range and accuracy above describe the DS18B20 IC specification, not a calibration certificate for each module. They do not establish the temperature rating of the complete PCB, header or wiring. This is an exposed board, not a sealed waterproof probe. Keep it dry; do not immerse it or put it directly against a heater. Connection and software checks With power disconnected, read the labels on the supplied PCB. Connect VCC to the suitable supply, GND to controller ground and DQ to the chosen digital GPIO. Do not infer the module header order from a bare TO-92 sensor drawing or another manufacturer's board. The 1-Wire data line needs a pull-up. Check the supplied module's existing components and pull-up connection before adding a resistor. A 3.3V-only controller must not receive a data line pulled up to 5V; verify voltage compatibility or use a suitable interface. For Arduino, OneWire and DallasTemperature are commonly used together. Select the connected data pin, discover the sensor, request a conversion, wait for completion and then read the result. Allow for the selected resolution and handle missing-sensor or failed-read conditions in the program. Placement and package Use it for learning, room-temperature logging or a controller display project. Position the sensor away from board heat and allow readings to settle. Includes 1 x DS18B20 digital temperature sensor module. Controller, jumper wires, display and power supply are not included. SKU: AB032.

More in Temperature & Humidity

You might also need