About this product
Supply Voltage: 9V DC
Input Impedance: 1M OHM
Maximum Real-time Sampling Rate: Msps
Sampling Buffer Depth: 1024 Bytes
Description:
This is DSO138 2.4″ TFT Handheld Pocket-size Digital Oscilloscope Kit. This DSO138 digital oscilloscope kit adopts ARM Cortex-M3 processor and with 2.4-inch TFT screen. It’s easy and reliable for circuit operation. It can display frequency, period, pulse width, duty ratio, MAX./MIN./AVG./Peak-Peak/virtual values. This boost converter is a great match for DSO138 oscilloscope kit. It can be connected directly to the DSO138 motherboard(not included), make DSO138 oscilloscope to be a portable oscilloscope for better use.
Specification:
Supply Voltage
9V DC
Input Impedance
1MΩ
Maximum Real-time Sampling Rate
1Msps
Sampling Buffer Depth
1024 bytes
Analog Bandwidth
0-200KHz
Vertical Sensitivity
10mV / Div – 5V / Div (1-2-5 progressive manner)
Accuracy
12Bit
Coupling Modes
DC / AC / GND
The Horizontal Time Base Range
10μs / Div – 50s / Div (1-2-5 progressive manner)
Features:
This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as the ARM test development board.
Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, data loggers.
Adjustable vertical displacement, and with instructions.
With automatic, regular and one-shot modes, easy to capture the moment waveform.
Available rising or falling edge trigger.
Observable previous trigger waveform (negative delay).
Can freeze at any time waveform display (the HOLD function).
Comes 1Hz /3.3V square wave test signal source.
With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX./MIN./AVG./Peak-Peak/virtual values.
Product Documents and firmware:
Users Manual [for 13801K/02K(discontinued)]
Users Manual [for 13803K/04K]
Assembly Drawing
Surface Mount Component Installation Guide
SMD Part List
Firmware
Source codes [basic version]
DSO138 Library
How to Use the DSO138 Library
Schematic of the LCD board
How to Upgrade firmware for DSO138
Package Included:
1 x DIY Digital Oscilloscope Kit
1 x Probe
This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as the ARM test development board.
Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, data loggers.
Adjustable vertical displacement, and with instructions.
With automatic, regular and one-shot modes, easy to capture the moment waveform.
Available rising or falling edge trigger.
Observable previous trigger waveform (negative delay).
Can freeze at any time waveform display (the HOLD function).
Comes 1Hz /3.3V square wave test signal source.
With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX./MIN./AVG./Peak-Peak/virtual values.