Control the rotation of SG-90 Servo Motor using Ball Switch Module -KT606

SKU KT606

In this project we will be controlling the rotation of Servo Motor using Ball switch module. Arduino IDE 1.8.5 (programmable platform for Arduino) It consists of a 10kΩ resistor

₹1723.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

Hardware Required

Arduino Uno With USB Cable - 1

Ball Switch Module - 1

SG-90 Servo Motor - 1

9v Battery - 1

Snapper With DC Jack - 1

Jumper Wire (male to male) - 40 pcs

Jumper Wire (male to female) - 40 pcs

400 pt Breadboard -1

Introduction In this project we will be controlling the rotation of Servo Motor using Ball switch module. HARDWARE REQUIRED

Arduino Uno With USB Cable - 1

Ball Switch Module - 1

SG-90 Servo Motor - 1

9v Battery - 1

Snapper With DC Jack - 1

Jumper Wire (male to male) - 40 pcs

Jumper Wire (male to female) - 40 pcs

400 pt Breadboard -1

SOFTWARE REQUIRED Arduino IDE 1.8.5 (programmable platform for Arduino) Click To Download:https://www.arduino.cc/en/Main/Software SPECIFICATIONS

Ball Switch Sensor Module It consists of a 10kΩ resistor and a metallic ball switch with bidirectional conduction that will open/close the circuit depending on its tilt degree. It does not measure tilt angle. Closes the circuit when it is tilted to the side as long as it is moved with enough force & degree of inclination to activate ball switch inside.

Operating Voltage: 5v DC.

This module is small and simple to use.

Digital switch output (0 & 1)

High sensitivity

Completes the circuit when the module is tilted

LED lights up when tilt switch is activated

Arduino Uno

CIRCUIT CONNECTION

Connect GND of Servo motor with GND of Arduino Uno.

Connect VCC of Servo motor with Pin 5V of Arduino Uno.

Connect Pin Signal of Servo Motor with Digital Pin 9 of Arduino Uno.

Connect GND of Ball Sensor with GND of Arduino Uno.

Connect VCC of Ball Sensor with Pin 3.3V of Arduino Uno.

Connect Pin Signal of Ball Sensor with Digital Pin 2 of Arduino Uno

CODE https://drive.google.com/open?id=1PPJPe9WbPYzVD4oCXl2PXH-l2VRMxjON

WORKING Welcome to the Arduino Based Project which consists of Ball switch Module and Servo Motor. The basic principle of Ball switch sensor is being described here. The ball tilt switch module can detect when it is tilted. It works because a ball flows into the gap between two electrodes and completes the circuit when the module is tilted at an angle.Here, we are controlling the rotation of Servo Motor using Ball switch. When the ball switch module is tilted, then the Servo motor rotates at 90° on either direction.

More in Arduino Boards

You might also need